ASTM-E471:2022 Edition

$29.79

E471-22 Standard Test Method for Obtaining Char Density Profile of Ablative Materials by Machining and Weighing

Published By	Publication Date	Number of Pages
ASTM	2022	3

Guaranteed Safe Checkout

Categories: 49.025.40 - Rubber and plastics, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E471-22

Active Standard: Standard Test Method for Obtaining Char Density Profile of Ablative Materials by Machining and Weighing

ASTM E471

Scope

1.1 This test method covers the determination of the char density profile of a charred ablator that can be used with the following limitations:

1.1.1 The local surface imperfections must be removed, and the char must be able to be machined off in a plane parallel to the char-virgin material interface before the density profiles can be determined.

1.1.2 The char must be strong enough to withstand the machining and handling techniques employed.

1.1.3 The material should have orderly density variations. The total thickness of the char and degradation zone must be larger than the machining thicknesses required.

1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 Exception—Certain inch-pound equivalent units are included in parentheses for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

ablation; char density; density profile ;

ICS Code

ICS Number Code 49.025.40 (Rubber and plastics)

DOI: 10.1520/E0471-22

Additional information

Standard Title	E471-22 Standard Test Method for Obtaining Char Density Profile of Ablative Materials by Machining and Weighing
Published Code	ASTM
Publication Date	2022
Pages Count	3
ICS Codes	49.025.40 - Rubber and plastics