Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASSE 1066 1997

ASSE 1066 1997

$24.38

ASSE Standard #1066 1997 Performance Requirements for Individual Pressure Balancing In-Line Valves for Individual Fixture Fittings

Published By Publication Date Number of Pages
ASSE 1997 24
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Automatic pressure balancing in-line valves are used to equalize incoming hot and cold water line pressures for minimizing mixed water temperature variations due to pressure fluctuations when used with a mixing valve or two handle valve set. They are not designed to limit the maximum outlet temperature at the point-of-use. The device is intended for use in individual plumbing fixtures fittings such as shower heads, bath utility faucets and sink and lavatory faucets.

PDF Catalog

PDF Pages PDF Title
9 Section I
1.0 General
1.1 Application
1.2 Scope
Table 1
10 1.3 Literature
1.4 Reference Standards
Section II
2.0 Test Specimens
2.1 Samples Submitted
2.2 Samples Tested
2.3 Drawings
2.4 Rejection
11 Section III
3.0 Performance Requirements and Compliance Testing
3.1 Test Sequence
3.2 High Temperature Test
3.3 Hydrostatic Pressure Test
12 Figure 1
Table 2
13 3.4 Flow Rate Test
Figure 2
3.5 Temperature Variation Test
15 Figure 3
16 3.6 Line Pressure Supply Failure Test
3.7 Life Cycle Test
17 Figure 4
3.8 Cross Flow Test Procedure
18 3.9 Burst Pressure Test
19 Section IV
4.0 Detailed Requirements
4.1 Materials
4.2 Markings and Installation Instructions
4.3 Drawings and Installation Instructions
20 Section V
5.0 Definitions

Related products

ASSE 1066 1997
$24.38