BS EN 1395-5:2018
$102.76
Thermal spraying. Acceptance inspection of thermal spraying equipment – Plasma spraying in chambers
| Published By | Publication Date | Number of Pages |
| BSI | 2018 | 16 |
This European Standard specifies requirements for the acceptance inspection of thermal spraying equipment, in this case the pressurized part only for low pressure and controlled atmosphere plasma spraying, used in spray jobs to produce thermally sprayed coatings of reproducible quality. This part is intended to be used in conjunction with EN 1395-1, which includes general requirements and explanations of procedures. The plasma spraying system itself is intended to be acceptance inspected according to EN 1395-4.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | undefined |
| 6 | 1 Scope 2 Normative references 3 Terms and definitions |
| 7 | 4 Principles of acceptance inspection 4.1 General 4.2 Typical components 5 Procedure for acceptance inspection of vacuum components 5.1 General |
| 8 | 5.2 Low pressure performance of the pump station 5.3 Low pressure performance of the chamber 5.3.1 Preparation 5.3.2 Determination of the leakage rate (QL) |
| 9 | 5.3.3 Assessment of leakage rate 5.4 Function test |
| 10 | 6 Designation 7 Inspection report |
| 11 | Annex A (informative)Inspection report for chamber and pump systems for plasma spraying in controlled atmosphere (initial test/retest) |
| 13 | Annex B (informative)Diagram for the chronological sequence of the pressure change in chamber and an example for the calculation of the leakage rate B.1 Diagram |
| 14 | B.2 Example for the calculation |
Related products
-
BS EN 1395-5:2018 – TC:2020 Edition
Tracked Changes. Thermal spraying. Acceptance inspection of thermal spraying equipment – Plasma spraying in chambers…
