BS EN 17085:2019
$86.31
Paper and board. Sampling procedures for paper and board for recycling
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 14 |
This document specifies a method of obtaining representative samples from a lot of paper and board for recycling for testing to determine whether or not its composition and quality complies with the requirements of EN 643 and/or other specifications. This document also specifies the positioning of probes, when in situ measurements are performed. It defines the sampling procedures which apply when sampling is carried out to resolve compliance issues and commercial disputes between buyer and seller relating to a lot of paper and board for recycling, at any point in the value chain, where those procedures are not defined in the contract between buyer and seller. This document is not specifically intended for routine monitoring of processes or quality, but the procedures described may be used to form the basis of an agreement between supplier and buyer. This document is not applicable if the material is not intended for recycling. The method is not intended for determining the variability within a lot, however the general sampling principles can be applied.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 4 | Contents Page |
| 5 | European foreword |
| 6 | Introduction |
| 7 | 1 Scope 2 Normative references 3 Terms and definitions |
| 8 | 4 Principle 5 Sampling 5.1 Frequency 5.2 General guidance |
| 9 | 5.3 Loose material |
| 10 | 5.4 Baled material 5.4.1 Manual sampling 5.4.2 Core sampling |
| 11 | 5.5 Sample labelling 5.6 Storage of samples |
| 12 | 6 Micro-sampling procedure 6.1 General 6.2 Extraction of micro-sample 6.3 Storage of micro-samples 7 Sampling report |
| 13 | Bibliography |
