ASTM-A684 2006

$35.75

A684/A684M-06 Standard Specification for Steel, Strip, High-Carbon, Cold-Rolled

Published By	Publication Date	Number of Pages
ASTM	2006	4

Guaranteed Safe Checkout

Categories: 77.140.50 - Flat steel products and semi-products, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers cold-rolled, high-carbon strip. It is furnished in the following types as specified:

1.1.1 Soft spheroidized annealed high-carbon steel is intended for applications requiring maximum cold forming. It is normally produced to give the lowest maximum Rockwell hardness for each grade.

1.1.2 Soft annealed high-carbon steel is intended for applications requiring moderate cold forming. It is produced to a maximum Rockwell hardness.

1.1.3 Intermediate hardness high-carbon steel is intended for applications where cold forming is slight or a stiff, springy product is needed, or both. It is produced to specified Rockwell hardness ranges, the maximum being higher than obtained for the annealed type.

1.1.4 Full hard high-carbon steel is intended for flat applications. It is produced to minimum Rockwell hardness requirements, which vary with grade, microstructure and gage. Full hard can be produced with either a pearlitic or spheroidized microstructure or a mixture of both. The minimum hardness should be established between the consumer and the producer.

1.2 This specification is applicable for orders in either inch-pound units or SI units.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two system may result in non-conformance with the standard.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Ordering Information
2	Manufacture Chemical Requirements Metallurgical Structure Mechanical Requirements FIG. 1
3	Finish and Edges General Requirements FIG. 2 TABLE 1 TABLE 2

Additional information

Standard Title	A684/A684M-06 Standard Specification for Steel, Strip, High-Carbon, Cold-Rolled
Published Code	ASTM
Publication Date	2006
Pages Count	4
ICS Codes	77.140.50 - Flat steel products and semi-products

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-A684 2006

PDF Catalog

Related products