ASTM-A803 2001
$40.63
A803/A803M-01 Standard Specification for Welded Ferritic Stainless Steel Feedwater Heater Tubes
| Published By | Publication Date | Number of Pages |
| ASTM | 2001 | 7 |
ASTM A803/A803M-01
Historical Standard: Standard Specification for Welded Ferritic Stainless Steel Feedwater Heater Tubes
ASTM A803/A803M
Scope
1.1 This specification covers welded ferritic stainless steel feedwater heater tubes including those bent, if specified, into the form of U-tubes for application in tubular feedwater heaters.
1.2 The tubing sizes covered shall be 5/8 to 1 in. [15.9 to 25.4 mm] inclusive, in outside diameter, and average or minimum wall thicknesses of 0.028 in. [0.7 mm] and heavier.
1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.
Keywords
feedwater heater tubes; ferritic steel; seamless steel tube; stainless steel tube; steel tube; welded steel tube
ICS Code
ICS Number Code 23.040.10 (Iron and steel pipes)
DOI: 10.1520/A0803_A0803M-01
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology Ordering Information General Requirements Materials and Manufacture Cleaning Before Annealing |
| 2 | Heat Treatment Chemical Composition Mechanical Requirements TABLE 1 |
| 3 | Corrosion Resisting Properties TABLE 2 TABLE 3 TABLE 4 |
| 4 | Workmanship, Finish, and Appearance Surface Condition FIG. 1 TABLE 5 |
| 5 | Nondestructive Test (Electric Test) Inspection Rejection Certification Product Marking Packaging Keywords TABLE 6 |
| 6 | TABLE S1.1 FIG. S1.1 TABLE S2.1 |
