Shopping Cart

No products in the cart.

ASTM-C1113:1999 Edition

$35.75

C1113-99 Standard Test Method for Thermal Conductivity of Refractories by Hot Wire (Platinum Resistance Thermometer Technique)

Published By Publication Date Number of Pages
ASTM 1999 6
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

ASTM C1113-99

Historical Standard: Standard Test Method for Thermal Conductivity of Refractories by Hot Wire (Platinum Resistance Thermometer Technique)

ASTM C1113

Scope

1.1 This test method covers the determination of the thermal conductivity of non-carbonaceous, dielectric refractories.

1.2 Applicable refractories include refractory brick, refractory castables, plastic refractories, ramming mixes, powdered materials, granular materials, and refractory fibers.

1.3 Thermal conductivity k-values can be determined from room temperature to 1500Ā°C, or the maximum service temperature limit of the refractory, or to the temperature at which the refractory is no longer dielectric.

1.4 This test method is applicable to refractories with k-values less than 15 W/m[dot]K (100 Btu[dot]in./h[dot]ft2[dot]Ā°F).

1.5 In general it is difficult to make accurate measurements on anistropic materials, particularly those containing fibers, and the use of this test method for such materials should be agreed between the parties concerned.

1.6 The values stated in SI units are to be regarded as standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

hot wire; refractories; thermal conductivity

ICS Code

ICS Number Code 81.080 (Refractories)

DOI: 10.1520/C1113-99

ASTM-C1113
$35.75