ASTM-C505 2011

$40.63

C505-11 Standard Specification for Nonreinforced Concrete Irrigation Pipe with Rubber Gasket Joints

Published By	Publication Date	Number of Pages
ASTM	2011	5

Guaranteed Safe Checkout

Categories: 23.040.50 - Pipes and fittings of other materials, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM C505-11

Historical Standard: Standard Specification for Nonreinforced Concrete Irrigation Pipe with Rubber Gasket Joints

ASTM C505

Scope

1.1 This specification covers nonreinforced concrete pipe with rubber gasket joints to be used for the conveyance of irrigation water with working pressures, including hydraulic transients, as shown in Table 1.

1.2 A complete metric companion to Specification C505 has been developedC505M; therefore, no SI equivalents are presented in this specification.

Note 1—This specification is for manufacturing and purchase only and does not include requirements for bedding, backfill, installation, or field repairs. The owner is cautioned that he must correlate field conditions with the characteristics of the pipe specified and provide inspection during installation.

TABLE 1 Standard Dimensions, Working Pressures, and Test Requirements

^A Thinner walls are not prohibited on pipe units not over 4 ft in length, but the thickness of such walls shall not be less than the internal diameter divided by 10.

^B With the exception of 21 and 24-in. pipe, higher working pressures are not prohibited to be used up to a maximum of 50 ft for 6 through 12-in. diameters, and 40 ft for 15 through 18-in. diameters. In these cases the strength of the pipe shall be increased to give minimum internal hydrostatic test pressures of at least three times the design working pressure when tested as specified in 10.4.

^C For hydrostatic test requirements, refer to 10.4.

Keywords

absorption; acceptance criteria; concrete; design; drainage; gasket tests; gaskets; hydrostatic; irrigation; joints; manufacture; nonreinforced; pipe; pressure; rubber gaskets; tests; three-edge bearing: Concrete pipe (nonreinforced)–specifications; Gaskets–specifications; Irrigation piping–specifications; Joints (concrete applications)–specifications; Pressure pipelines/piping systems–specifications; Watertight joints

ICS Code

ICS Number Code 23.040.50 (Pipes and fittings of other materials)

DOI: 10.1520/C0505-11

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Classification Basis of Acceptance TABLE 1
2	Materials and Manufacture Design Joints
3	Concrete Mixture Physical Requirements
4	Gasket Lubricants Permissible Variations Workmanship, Finish, and Appearance Repairs Inspection Rejection Product Marking Keywords