ASTM-D2593 2009
$40.63
D2593-93(2009) Standard Test Method for Butadiene Purity and Hydrocarbon Impurities by Gas Chromatography
| Published By | Publication Date | Number of Pages |
| ASTM | 2009 | 7 |
1.1 This test method covers the determination of butadiene-1,3 purity and impurities such as propane, propylene, isobutane, n -butane, butene-1, isobutylene, propadiene, trans -butene-2, cis -butene-2, butadiene-1,2, pentadiene-1,4, and, methyl, dimethyl, ethyl, and vinyl acetylene in polymerization grade butadiene by gas chromatography. Impurities including butadiene dimer, carbonyls, inhibitor, and residue are measured by appropriate ASTM procedures and the results used to normalize the component distribution obtained by chromatography.
Note 1Other impurities present in commercial butadiene must be calibrated and analyzed. Other impurities were not tested in the cooperative work on this test method.
Note 2This test method can be used to check for pentadiene-1,4 and other C 5 s instead of Test Method .
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.1 and 9.3.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Summary of Test Method Significance and Use Apparatus |
| 2 | Reagents and Materials Preparation of Apparatus FIG. 1 |
| 3 | Calibration Procedure Calculation |
| 4 | Precision and Bias Keywords X1. COLUMNS AND CONDITIONS X1.1 |
| 5 | TABLE X1.1 |
Related products
-
ASTM-D2563 2002
D2563-94(2002)e1 Standard Practice for Classifying Visual Defects in Glass-Reinforced Plastic Laminate Parts Published By Publication…
-
ASTM-D5293 2008
D5293-08e1 Standard Test Method for Apparent Viscosity of Engine Oils Between -5 and -35°C Using…
-
ASTM-D2893 2019(Redline)
D2893-19 Standard Test Methods for Oxidation Characteristics of Extreme-Pressure Lubrication Oils (Redline) Published By Publication…
-
ASTM-D2523 2006(Redline)
D2523-00(2006) Standard Practice for Testing Load-Strain Properties of Roofing Membranes (Redline) Published By Publication Date…
-
ASTM-D2563 2008
D2563-08 Standard Practice for Classifying Visual Defects in Glass-Reinforced Plastic Laminate Parts Published By Publication…
-
ASTM-D2493 2009
D2493/D2493M-09 Standard Viscosity-Temperature Chart for Asphalts Published By Publication Date Number of Pages ASTM 2009…
-
ASTM-D2563 2008(Redline)
D2563-08 Standard Practice for Classifying Visual Defects in Glass-Reinforced Plastic Laminate Parts (Redline) Published By…
-
ASTM-D5293 2009
D5293-09 Standard Test Method for Apparent Viscosity of Engine Oils Between -5 and -35°C Using…
-
ASTM-D2590 2006
D2590-98(2006)e1 Standard Test Method for Sampling Chrysotile Asbestos Published By Publication Date Number of Pages…
-
ASTM-D2594 2008
D2594-04(2008)e1 Standard Test Method for Stretch Properties of Knitted Fabrics Having Low Power Published By…
-
ASTM-D2493 2009(Redline)
D2493/D2493M-09 Standard Viscosity-Temperature Chart for Asphalts (Redline) Published By Publication Date Number of Pages ASTM…
-
ASTM-D2539 2001
D2539-93(2001) Standard Test Method for Shock Sensitivity of Liquid Monopropellants by the Card-Gap Test (Withdrawn…
-
ASTM-D2503 2002
D2503-92(2002)e1 Standard Test Method for Relative Molecular Mass (Molecular Weight) of Hydrocarbons by Thermoelectric Measurement…
-
ASTM-D6593 2009
D6593-09a Standard Test Method for Evaluation of Automotive Engine Oils for Inhibition of Deposit Formation…
-
ASTM-D2583 2007
D2583-07 Standard Test Method for Indentation Hardness of Rigid Plastics by Means of a Barcol…
-
ASTM-D2493 2001
D2493-01 Standard Viscosity-Temperature Chart for Asphalts Published By Publication Date Number of Pages ASTM 2001…
-
ASTM-D2493 2001
D2493-01e1 Standard Viscosity-Temperature Chart for Asphalts Published By Publication Date Number of Pages ASTM 2001…
-
ASTM-D2593 2019(Redline)
D2593-19 Standard Test Method for Butadiene Purity and Hydrocarbon Impurities by Gas Chromatography (Redline) Published…
-
ASTM-D2573 2007
D2573-01(2007) Standard Test Method for Field Vane Shear Test in Cohesive Soil Published By Publication…
-
ASTM-D2598 2002
D2598-02 Standard Practice for Calculation of Certain Physical Properties of Liquefied Petroleum (LP) Gases from…
-
ASTM-D2593 2004
D2593-93(2004)e1 Standard Test Method for Butadiene Purity and Hydrocarbon Impurities by Gas Chromatography Published By…
-
ASTM-D2893 2009
D2893-04(2009) Standard Test Method for Oxidation Characteristics of Extreme-Pressure Lubrication Oils Published By Publication Date…
-
ASTM-D2590 2002
D2590-98(2002) Standard Test Method for Sampling Chrysotile Asbestos Published By Publication Date Number of Pages…
-
ASTM-D2523 2000
D2523-00 Standard Practice for Testing Load-Strain Properties of Roofing Membranes Published By Publication Date Number…
-
ASTM-D2573 2001
D2573-01e1 Standard Test Method for Field Vane Shear Test in Cohesive Soil Published By Publication…
-
ASTM-D2596 2002
D2596-97(2002)e1 Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Grease (Four-Ball Method) Published…
-
ASTM-D2583 2007(Redline)
D2583-07 Standard Test Method for Indentation Hardness of Rigid Plastics by Means of a Barcol…
-
ASTM-D2583 2001
D2583-95(2001)e1 Standard Test Method for Indentation Hardness of Rigid Plastics by Means of a Barcol…
-
ASTM-D2593 2019
D2593-19 Standard Test Method for Butadiene Purity and Hydrocarbon Impurities by Gas Chromatography Published By…
-
ASTM-D2503 2007
D2503-92(2007) Standard Test Method for Relative Molecular Mass (Molecular Weight) of Hydrocarbons by Thermoelectric Measurement…
-
ASTM-D2595 2002
D2595-96(2002)e1 Standard Test Method for Evaporation Loss of Lubricating Greases Over Wide-Temperature Range Published By…
-
ASTM-D6593 2009
D6593-09 Standard Test Method for Evaluation of Automotive Engine Oils for Inhibition of Deposit Formation…
-
ASTM-D2590 2002
D2590-98(2002)e1 Standard Test Method for Sampling Chrysotile Asbestos Published By Publication Date Number of Pages…
-
ASTM-D6593 2007
D6593-07 Standard Test Method for Evaluation of Automotive Engine Oils for Inhibition of Deposit Formation…
-
ASTM-D6593 2007
D6593-07a Standard Test Method for Evaluation of Automotive Engine Oils for Inhibition of Deposit Formation…
-
ASTM-D2893 2009(Redline)
D2893-04(2009) Standard Test Method for Oxidation Characteristics of Extreme-Pressure Lubrication Oils (Redline) Published By Publication…
-
ASTM-D2293 2008
D2293-96(2008) Standard Test Method for Creep Properties of Adhesives in Shear by Compression Loading (Metal-to-Metal)…
-
ASTM-D2597 2004
D2597-94(2004) Standard Test Method for Analysis of Demethanized Hydrocarbon Liquid Mixtures Containing Nitrogen and Carbon…
-
ASTM-E2593 2007
E2593-07 Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers Published By Publication Date…
-
ASTM-D2594 2004
D2594-04 Standard Test Method for Stretch Properties of Knitted Fabrics Having Low Power Published By…
