ASTM-D3451:2006 Edition

$44.96

D3451-06 Standard Guide for Testing Coating Powders and Powder Coatings

Published By	Publication Date	Number of Pages
ASTM	2006	13

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This guide covers the selection and use of procedures for testing coating powders and powder coatings. The test methods included are listed in . Where more than one test method is listed for the same characteristic, no attempt is made to indicate superiority of one method over another. Selection of the methods to be followed must be governed by experience and the requirements in each individual case, together with agreement between the purchaser and the seller.

1.2 This guide also refers to methods developed specifically for the coating powder industry by the Powder Coating Institute, PCI, and the International Organization for Standards, ISO.

1.3 This guide describes the testing of coating powders as applied by electrostatic spray, fluidized bed, or any other applicable method.

1.4

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
3	Terminology
4	TABLE 1
5	Significance and Use General Requirements
6	Sampling Equipment Conditions Affecting Coating Powder or Powder Coatings, or Both Compatibility Minimum Explosive Concentration (Lower Explosive Level (LEL)) Particle Size and Distribution Accelerated Storage Stability Pourability Fluidity Cured Weight Loss for Thermosetting Coating Powders
7	Gel Time or Stroke Cure (for Thermosetting Powder Only) Flow Test (Incline Method) Specific Gravity (Density) of Coating Powders Melting Point Determination
8	Determining the Relative Deposition Efficiency of Coating Powders on a Moving Target Panel Preparation Abrasion Resistance Adhesion Chemical Resistance
9	Chip Resistance Corner Coverage Elongation (Flexibility) Hardness Impact Resistance Mottling/Blocking Resistance Print Resistance Optical Properties
10	Outdoor Exposures (Natural)
11	Accelerated Artificial Weathering
12	Accelerated Environmental Exposure Keywords