ASTM-D3900 2004

$40.63

D3900-95(2004)e1 Standard Test Methods for Rubber-Determination of Ethylene Units in Ethylene-Propylene Copolymers (EPM) and in Ethylene-Propylene-Diene Terpolymers (EPDM) by Infrared Spectrometry

Published By	Publication Date	Number of Pages
ASTM	2004	9

Guaranteed Safe Checkout

Categories: 83.040.10 - Latex and raw rubber, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 These test methods cover the determination of the proportion of ethylene and propylene units in ethylene-propylene copolymers (EPM) and ethylene-propylenediene terpolymers (EPDM) over the range from 35 to 85 mass % ethylene. Four test methods are needed to encompass the variety of commercial polymers that contain additives or polymerized diene units that interfere with the various infrared peaks. Except when interferences are present, all four test methods should give similar results. The test methods appear in the following order:

1.1.1 Pressed Film Test Methods

1.1.2 Cast Film Test Methods

1.2 These test methods are not applicable to oil-extended EPDM unless the oil is first removed in accordance with Test Method D.

1.3 The values stated in SI units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Summary of Test Methods
2	Significance and Use Interferences Apparatus Sampling TABLE 1
3	Scope Summary of Test Method TABLE 2
4	Reagents and Materials Procedure FIG. 1
5	Calculation Scope Summary of Test Method Procedure FIG. 2
6	Calculation Scope Summary of Test Method Procedure FIG. 3
7	Calculation Scope Summary of Test Method Apparatus Reagents and Materials Sample Preparation
8	Procedure FIG. 4
9	Calculation Keywords FIG. 5

Additional information

	Sections
Test Method B -For EPM and EPDM between 60 and 85 mass % ethylene, except for ethylene/propylene/1,4-hexadiene terpolymers
Test Method A -For EPM and EPDM between 35 and 65 mass % ethylene
Test Method D -For all EPM and EPDM polymers between 35 and 85 mass % ethylene, except for ethylene/propylene/1,4-hexadiene terpolymers
Test Method C -For all EPM and EPDM polymers between 35 and 85 mass % ethylene, using near infrared
ICS Codes	83.040.10 - Latex and raw rubber

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D3900 2004

PDF Catalog

Related products