🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-D4310:2006 Edition

ASTM-D4310:2006 Edition

$44.96

D4310-06 Standard Test Method for Determination of Sludging and Corrosion Tendencies of Inhibited Mineral Oils

Published By Publication Date Number of Pages
ASTM 2006 11
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This test method is used to evaluate the tendency of inhibited mineral oil based steam turbine lubricants and mineral oil based anti-wear hydraulic oils to corrode copper catalyst metal and to form sludge during oxidation in the presence of oxygen, water, and copper and iron metals at an elevated temperature. The test method is also used for testing circulating oils having a specific gravity less than that of water and containing rust and oxidation inhibitors.

Note 1During round robin testing copper and iron in the oil, water and sludge phases were measured. However, the values for the total iron were found to be so low (that is, below 0.8 mg), that statistical analysis was inappropriate. The results of the cooperative test program are available.

1.2 This test method is a modification of Test Method D 943 where the oxidation stability of the same kinds of oils is determined by following the acid number of oil. The number of test hours required for the oil to reach an acid number of 2.0 mg KOH/g is the oxidation lifetime .

1.3 The values state in SI units are to be regarded as standard. No ther units of measurement are included in this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 7 and X1.1.5.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Summary of Test Method
2 Significance and Use
Apparatus
FIG. 1
3 Reagents and Materials
4 FIG. 2
5 Sampling
Preparation of Apparatus
FIG. 3
6 Procedure for Oxidizing the Oil
7 Procedure for Determination of Sludge Weight
FIG. 4
8 Procedure for Determination of Copper in Oil, Water, and Sludge
FIG. 5
9 Calculations
Report
Precision and Bias
10 Keywords
X1. PROCEDURE FOR PACKAGING CATALYST COILS
X1.1 Materials
X1.2 Procedure
11 X2. OPTIONAL CORROSION INDICATOR
X2.1
TABLE X2.1
TABLE X2.2

Related products

ASTM-D4310
$44.96