ASTM-D4504 2018

1.1 This specification covers molded polyethylene, open-head, self-supporting, nonreusable pails intended for the packaging and transportation of nonhazardous goods. Pails are to have volume capacities between 1 and 7 gal (3.8 to 26.5 L).

1.2 Pails intended to contain hazardous goods (materials) shall be in accordance with and tested to United States Department of Transportation Code of Federal Regulations (CFR) Title 49, Parts (100–199).

1.3 The purpose of this specification is to establish performance requirements and test methods for molded open-head polyethylene pails.

1.4 Additives for the resin used and design of the pails are left to the discretion of the supplier, within the allowable limits of regulatory and performance requirements.

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 The following safety hazards caveat pertains to the test method portions, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.