ASTM-D5677 2010

$40.63

D5677-05(2010) Standard Specification for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type, for Aviation Jet Turbine Fuel Lines

Published By	Publication Date	Number of Pages
ASTM	2010	5

Guaranteed Safe Checkout

Categories: 23.040.20 - Plastics pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D5677-05-Reapproved2010

Historical Standard: Standard Specification for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type, for Aviation Jet Turbine Fuel Lines

ASTM D5677

Scope

1.1 This specification covers a reinforced plastic pipe and fittings system made from epoxy resin and glass-fiber reinforcement, together with adhesive for joint assembly, intended for service up to 150°F (65.6°C) and 150-psig (1034-kPa) operating pressure and surges up to 275 psig (1896 kPa) in aviation jet turbine fuel lines installed below ground.

1.2 The dimensionless designator NPS has been substituted in this specification for such traditional terms as nominal diameter, size, and nominal size.

1.3 The values stated in inch-pound units are to be regarded as standard. The values in parentheses are for information only.

1.4 The following safety hazards caveat pertains only to the test method portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this standard.

Keywords

beam strength; boil resistance; centrifugally cast; cycling resistance; epoxy resins; filament wound; impact resistance; jet fuel; joint strength; molded; Adhesive-bonded joints; Aviation turbine fuels–specifications; Beam strength; Boil resistance; Centrifugally cast plastic pipe–specifications; Cycling resistance; Drop tests; Epoxy resin pipe fittings–specifications; Falling ball test; Fiberglass pipe–specifications; Filament-wound plastic pipe; Impact resistance–plastics; Joint strength

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/D5677-05R10

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Classification
2	Materials and Manufacture Dimensions Performance Requirements TABLE 1
3	Workmanship Test Methods
4	Inspection
5	Certification Product Marking Packaging Keywords

Additional information

Standard Title	D5677-05(2010) Standard Specification for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type, for Aviation Jet Turbine Fuel Lines
Published Code	ASTM
Publication Date	2010
Pages Count	5
ICS Codes	23.040.20 - Plastics pipes