ASTM-D6082 2001
$40.63
D6082-01 Standard Test Method for High Temperature Foaming Characteristics of Lubricating Oils
| Published By | Publication Date | Number of Pages |
| ASTM | 2001 | 8 |
ASTM D6082-01
Historical Standard: Standard Test Method for High Temperature Foaming Characteristics of Lubricating Oils
ASTM D6082
Scope
1.1 This test method describes the procedure for determining the foaming characteristics of lubricating oils (specifically transmission fluid and motor oil) at 150°C.
1.2 Foaming characteristics of lubricating oils at temperatures up to 93.5°C are determined by Test Method D 892 or IP 146 .
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.
Keywords
foaming; high temperature lubrication; lubricants
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
DOI: 10.1520/D6082-01
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Summary of Test Method Significance and Use FIG. 1 |
| 3 | Apparatus Reagents FIG. 2 |
| 4 | Preparation of Apparatus FIG. 3 |
| 5 | Calculations and Results Report |
| 6 | Precision and Bias Keywords A1.1 Apparatus TABLE 1 FIG. A1.1 |
| 7 | A1.2 Procedure X1. HELPFUL HINTS FOR THE ANALYST X1.1 X1.2 X1.3 X1.4 X1.5 X1.6 X1.7 X1.8 X1.9 X1.10 X1.11 X1.12 X1.13 FIG. A1.2 |
| 8 | X1.14 X1.15 X1.16 |
Related products
-
ASTM-D6092 2003
D6092-97(2003) Standard Practice for Specifying Standard Sizes of Stone for Erosion Control Published By Publication…
-
ASTM-D6802 2002
D6802-02 Test Method for Determination of the Relative Content Of Dissolved Decay Products in Mineral…
-
ASTM-D6682 2001
D6682-01 Standard Test Method for Measuring the Shear Stresses of Powders Using the Peschl Rotational…
-
ASTM-D4082 2010(Redline)
D4082-10 Standard Test Method for Effects of Gamma Radiation on Coatings for Use in Nuclear…
-
ASTM-D6032 2008(Redline)
D6032-08 Standard Test Method for Determining Rock Quality Designation (RQD) of Rock Core (Redline) Published…
-
ASTM-D6482 2021(Redline)
D6482-21 Standard Test Method for Determination of Cooling Characteristics of Aqueous Polymer Quenchants by Cooling…
-
ASTM-D6087 2001
D6087-97(2001) Standard Test Method for Evaluating Asphalt-Covered Concrete Bridge Decks Using Ground Penetrating Radar Published…
-
ASTM-D6032 2006
D6032-02(2006) Standard Test Method for Determining Rock Quality Designation (RQD) of Rock Core Published By…
-
ASTM-D6382 2011
D6382/D6382M-99(2011)e1 Standard Practice for Dynamic Mechanical Analysis and Thermogravimetry of Roofing and Waterproofing Membrane Material…
-
ASTM-D6582 2000
D6582-00 Standard Guide for Ranked Set Sampling: Efficient Estimation of a Mean Concentration in Environmental…
-
ASTM-D6482 2021
D6482-21 Standard Test Method for Determination of Cooling Characteristics of Aqueous Polymer Quenchants by Cooling…
-
ASTM-D6089 2003
D6089-97(2003) Standard Guide for Documenting a Ground-Water Sampling Event Published By Publication Date Number of…
-
ASTM-D6582 2005
D6582-00(2005)e1 Standard Guide for Ranked Set Sampling: Efficient Estimation of a Mean Concentration in Environmental…
-
ASTM-D6782 2005(Redline)
D6782-05 Standard Test Methods for Standardization and Calibration of In-Line Dry Lumber Moisture Meters (Redline)…
-
ASTM-D6082 2000
D6082-00 Standard Test Method for High Temperature Foaming Characteristics of Lubricating Oils Published By Publication…
-
ASTM-D6782 2004
D6782-04 Standard Test Methods for Standardization and Calibration of In-Line Dry Lumber Moisture Meters Published…
-
ASTM-D6082 2006
D6082-06 Standard Test Method for High Temperature Foaming Characteristics of Lubricating Oils Published By Publication…
-
ASTM-D6080 2010
D6080-10 Standard Practice for Defining the Viscosity Characteristics of Hydraulic Fluids Published By Publication Date…
-
ASTM-D6782 2005
D6782-05 Standard Test Methods for Standardization and Calibration of In-Line Dry Lumber Moisture Meters Published…
-
ASTM-D6088 2006
D6088-06 Standard Practice for Installation of Geocomposite Pavement Drains Published By Publication Date Number of…
-
ASTM-D6282 2005(Redline)
D6282-98(2005) Standard Guide for Direct Push Soil Sampling for Environmental Site Characterizations (Redline) Published By…
-
ASTM-D6062 2007
D6062-07 Standard Guide for Personal Samplers of Health-Related Aerosol Fractions Published By Publication Date Number…
-
ASTM-D7082 2010
D7082-04(2010) Standard Specification for Polyethylene Stay In Place Form System for End Walls for Drainage…
-
ASTM-D6088 2002
D6088-97(2002) Standard Practice for Installation of Geocomposite Pavement Drains Published By Publication Date Number of…
-
ASTM-D6084 2006
D6084-06 Standard Test Method for Elastic Recovery of Bituminous Materials by Ductilometer Published By Publication…
-
ASTM-D608 2001
D608-90(2001) Standard Specification for Dibutyl Phthalate Published By Publication Date Number of Pages ASTM 2001…
-
ASTM-D4082 2010
D4082-10 Standard Test Method for Effects of Gamma Radiation on Coatings for Use in Nuclear…
-
ASTM-D6092 2008
D6092-97(2008) Standard Practice for Specifying Standard Sizes of Stone for Erosion Control Published By Publication…
-
ASTM-D6982 2003
D6982-03 Standard Practice for Detecting Hot Spots and Buried Objects Using Point-Net (Grid) Search Patterns…
-
ASTM-D6028 2004
D6028-96(2004) Standard Test Method (Analytical Procedure) for Determining Hydraulic Properties of a Confined Aquifer Taking…
-
ASTM-D5082 2005
D5082-99(2005) Standard Practice for Application of Mechanically Attached Poly(Vinyl Chloride) Sheet Roofing Published By Publication…
-
ASTM-D6042 2009(Redline)
D6042-09 Standard Test Method for Determination of Phenolic Antioxidants and Erucamide Slip Additives in Polypropylene…
-
ASTM-D6482 2001
D6482-01 Standard Test Method for Determination of Cooling Characteristics of Aqueous Polymer Quenchants by Cooling…
-
ASTM-D6087 2005
D6087-05 Standard Test Method for Evaluating Asphalt-Covered Concrete Bridge Decks Using Ground Penetrating Radar Published…
-
ASTM-D6482 2011
D6482-06(2011) Standard Test Method for Determination of Cooling Characteristics of Aqueous Polymer Quenchants by Cooling…
-
ASTM-D6022 2001
D6022-01 Standard Practice for Calculation of Permanent Shear Stability Index Published By Publication Date Number…
-
ASTM-D3082 2009
D3082-09 Standard Test Method for Boron in Water Published By Publication Date Number of Pages…
-
ASTM-D7082 2021(Redline)
D7082-21 Standard Specification for Polyethylene Stay In Place Form System for End Walls for Drainage…
-
ASTM-D6052 2008
D6052-97(2008) Standard Test Method for Preparation and Elemental Analysis of Liquid Hazardous Waste by Energy-Dispersive…
-
ASTM-D6082 2011
D6082-11 Standard Test Method for High Temperature Foaming Characteristics of Lubricating Oils Published By Publication…
