ASTM-D6320 2004

$40.63

D6320-04 Standard Test Methods for Single Filament Hose Reinforcing Wire Made from Steel

Published By	Publication Date	Number of Pages
ASTM	2004	8

Guaranteed Safe Checkout

Categories: 77.140.65 - Steel wire, wire ropes and link chains, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D6320-04

Historical Standard: Standard Test Methods for Single Filament Hose Reinforcing Wire Made from Steel

ASTM D6320

Scope

1.1 These test methods cover testing of single filament steel wires that are used to reinforce hose products. By agreement, these test methods may be applied to similar filaments used for reinforcing other rubber products.

1.2 These test methods describe test procedures only and do not establish specifications or tolerances.

1.3 These test methods cover the determinations of the mechanical properties listed below:

1.4 These test methods are written in SI units; the inch-pound units which are provided are not necessarily exact equivalents of the SI units. Either system of units may be used in these test methods. In the case of referee decisions, the SI units will prevail.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 This test method covers the measurement of breaking force, yield strength, and elongation of single filament steel reinforcing wire in a tensile test.

1.6 This section describes the test procedure to determine the knot test characteristic of hydraulic hose wire with a diameter less than or equal to 0.82 mm (0.032 in.). In practice, the knot test is most suitable for wires less than 0.50 mm (0.020 in.).

1.7 This test method covers the determination of wire ductility by twisting a wire to failure.

1.8 This test method covers the determination of high stress fatigue performance and ductility by reverse bending wire to failure.

1.9 This test method covers determination of propensity of a wire to develop or propagate, or both, surface cracks from being wound. This test is also known as the wrap-around bend test.

1.10 This test method covers the measurement of the diameter and roundness of single filament wire using a micrometer.

Keywords

diameter; elongation; reverse bend; strength, breaking; strength, knot; torsion; wire, hose reinforcing; wrap

ICS Code

ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)

DOI: 10.1520/D6320-04

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Sampling Scope Summary of Test Method Significance and Use Apparatus Procedure
3	Calculation Report Precision and Bias Scope Significance and Use Apparatus Procedure FIG. 1 FIG. 2
4	Calculation Report Precision and Bias Scope Summary of Test Method Significance and Use Apparatus Procedure Calculation Report Precision and Bias
5	Scope Summary of Test Method Significance and Use Apparatus FIG. 3
6	Procedure Calculation Report Precision and Bias TABLE 1
7	Scope Summary of Test Method Significance and Use Apparatus Procedure Report Precision and Bias FIG. 4
8	Scope Significance and Use Apparatus Procedure Calculation Report Precision and Bias Keywords

Additional information

	Property
Knot strength
Breaking force (strength)
Wrap
Torsion resistance
Yield strength
Elongation
Diameter
Reverse bend
ICS Codes	77.140.65 - Steel wire, wire ropes and link chains