ASTM-D6766 2006

$40.63

D6766-06 Standard Test Method for Evaluation of Hydraulic Properties of Geosynthetic Clay Liners Permeated with Potentially Incompatible Liquids

Published By	Publication Date	Number of Pages
ASTM	2006	9

Guaranteed Safe Checkout

Categories: 59.080.70 - Geotextiles, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method covers laboratory measurement of both flux and hydraulic conductivity (also referred to as coefficient of permeability ) of geosynthetic clay liner (GCL) specimens permeated with chemical solutions and leachates utilizing a flexible wall permeameter. For test measurement of index hydraulic properties of geosynthetic clay liners, refer to Test Method D 5887.

1.2 This test method may be utilized with GCL specimens that have a hydraulic conductivity less than or equal to 1 10 ^-5 m/s (1 10 ^-3 cm/s).

1.3 This test method is applicable to GCL products having geotextile backing(s). It may not be applicable to GCL products with geomembrane backing(s).

1.4 This test method provides measurements of flux and hydraulic conductivity under a prescribed set of conditions, as an index test, that can be used for manufacturing quality control. The flux and hydraulic conductivity values determined using this test method under the prescribed set of conditions is not considered to be representative of the in-service conditions of GCLs. However, the test method allows the requester to establish a set of test conditions; thus, the test method also may be used to check performance or conformance, or both.

1.5 The values stated in SI units are to be regarded as the standard, unless other units are specifically given. By tradition in U.S. practice, hydraulic conductivity is reported in centimeters per second, although the common SI units for hydraulic conductivity are meters per second.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Significance and Use Apparatus
3	FIG. 1
4	FIG. 2
5	Reagents Test Specimen Preparation
6	Procedure FIG. 3
7	Calculation
8	Report Precision and Bias Keywords TABLE 1

Additional information

Standard Title	D6766-06 Standard Test Method for Evaluation of Hydraulic Properties of Geosynthetic Clay Liners Permeated with Potentially Incompatible Liquids
Published Code	ASTM
Publication Date	2006
Pages Count	9
ICS Codes	59.080.70 - Geotextiles

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D6766 2006

PDF Catalog

Related products