ASTM-D6875 2023(Redline)

$35.75

D6875-23 Standard Test Method for Solidification Point of Industrial Organic Chemicals by Thermistor (Redline)

Published By	Publication Date	Number of Pages
ASTM	2023

Guaranteed Safe Checkout

Categories: 71.080.01 - Organic chemicals in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D6875-23

Redline Standard: Standard Test Method for Solidification Point of Industrial Organic Chemicals by Thermistor

ASTM D6875

Scope

1.1 This test method covers a general procedure for determining the solidification point of most organic chemicals having appreciable heats of fusion and solidification points between 4 °C and 41 °C.

Note 1: Other test methods for determining freeze point and solidification point of aromatic hydrocarbons include Test Methods D852, D1015, D1016, D3799, D4493, and D6269.

1.2 This test method is applicable to relatively pure compounds only. Solidification point depression is dependent on impurity concentrations.

1.3 The following applies to all specified limits in this test method: for purposes of determining conformance with applicable specifications using this test method, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right hand digit used in expressing the specification limit, in accordance with the “rounding-off method” of Practice E29.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 8, Hazards.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

benzene; cyclohexane; p-Xylene; solidification point;

ICS Code

ICS Number Code 71.080.01 (Organic chemicals in general)

DOI: 10.1520/D6875-23

Additional information

Standard Title	D6875-23 Standard Test Method for Solidification Point of Industrial Organic Chemicals by Thermistor (Redline)
Published Code	ASTM
Publication Date	2023
ICS Codes	71.080.01 - Organic chemicals in general