ASTM-D7066 2024

$34.13

D7066-04(2024) Standard Test Method for dimer/trimer of chlorotrifluoroethylene (S-316) Recoverable Oil and Grease and Nonpolar Material by Infrared Determination

Published By	Publication Date	Number of Pages
ASTM	2024	9

Guaranteed Safe Checkout

Categories: 13.030.20 - Liquid wastes. Sludge, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D7066-04-Reapproved2024

Active Standard: Standard Test Method for dimer/trimer of chlorotrifluoroethylene (S-316) Recoverable Oil and Grease and Nonpolar Material by Infrared Determination

ASTM D7066

Scope

1.1 This test method covers the determination of oil and grease and nonpolar material in water and wastewater by an infrared (IR) determination of dimer/trimer of chlorotrifluoroethylene (S-316)2 extractable substances from an acidified sample. Included in this estimation of oil and grease are any other compounds soluble in the solvent.

1.2 This test method is applicable to measurement of the light fuel although loss of some light ends during extraction can be expected.

1.3 This test method defines oil and grease in water and wastewater as that which is extractable in the test method and measured by IR absorption at 2930 cm^-1 or 3.4 µm. Similarly, this test method defines nonpolar material in water and wastewater as that oil and grease which is not adsorbed by silica gel in the test method and measured by IR absorption at 2930 cm^-1.

1.4 This test method covers the range of 5 mg/L to 100 mg/L and may be extended to a lower or higher level by extraction of a larger or smaller sample volume collected separately.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine (Guide D3856) the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

grease; infrared determination; IR; non-polar material; oil; spectroscopy; water;

ICS Code

ICS Number Code 13.030.20 (Liquid wastes. Sludge)

DOI: 10.1520/D7066-04R24

Additional information

Standard Title	D7066-04(2024) Standard Test Method for dimer/trimer of chlorotrifluoroethylene (S-316) Recoverable Oil and Grease and Nonpolar Material by Infrared Determination
Published Code	ASTM
Publication Date	2024
Pages Count	9
ICS Codes	13.030.20 - Liquid wastes. Sludge