ASTM-D7472 2019
$35.75
D7472-19 Standard Specification for EFEP-Fluoropolymer Molding and Extrusion Materials
Published By | Publication Date | Number of Pages |
ASTM | 2019 | 4 |
ASTM D7472-19
Historical Standard: Standard Specification for EFEP-Fluoropolymer Molding and Extrusion Materials
ASTM D7472
Scope
1.1 This specification covers melt processible molding and extrusion materials of EFEP-fluoropolymer. The EFEP resin is a copolymer of ethylene, tetrafluoroethylene, and hexafluoropropylene.
1.2 This specification does not cover blended materials and does not cover recycled materials.
1.3 The values stated in SI units as detailed in IEEE/ASTM SI-10 are to be regarded as the standard. The values given in parentheses are for information only.
1.4 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: Although this specification and ISO 20568-1 and ISO 20568-2 differ in approach or detail, data obtained using either are technically equivalent.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
copolymer of ethylene, tetrafluoroethylene, and hexafluoropropylene ; EFEP copolymer; ETFE copolymer; ethylene copolymer; ethylene-tetrafluoroethylene copolymer; fluoropolymer; tetrafluoroethylene copolymer; TFE copolymer;
ICS Code
ICS Number Code 83.080.20 (Thermoplastic materials)
DOI: 10.1520/D7472-19