ASTM-D95 2005
$40.63
D95-05e1 Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation
Published By | Publication Date | Number of Pages |
ASTM | 2005 | 6 |
1.1 This test method covers the determination of water in the range from 0 to 25 % volume in petroleum products, tars, and other bituminous materials by the distillation method.
Note 1Volatile water-soluble material, if present, may be measured as water.
1.2 The specific products considered during the development of this test method are listed in Table 1. For bituminous emulsions refer to Test Method D 244. For crude oils, refer to Test Method D 4006 (API MPMS Chapter 10.2).
Note 2With some types of oil, satisfactory results may be obtained from Test Method D 1796 (API MPMS Chapter 10.6).
1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 6.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents Terminology |
2 | Summary of Test Method Significance and Use Solvent-Carrier Liquid Apparatus TABLE 1 FIG. 1 |
3 | Sampling Verification Procedure FIG. 2 |
4 | FIG. 3 TABLE 2 |
5 | Calculation Report Precision and Bias Keywords TABLE 3 TABLE 4 |