Shopping Cart

No products in the cart.

ASTM-D95 2010

$40.63

D95-05(2010) Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation

Published By Publication Date Number of Pages
ASTM 2010 6
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This test method covers the determination of water in the range from 0 to 25 % volume in petroleum products, tars, and other bituminous materials by the distillation method.

Note 1Volatile water-soluble material, if present, may be measured as water.

1.2 The specific products considered during the development of this test method are listed in Table 1. For bituminous emulsions refer to Test Method D244 . For crude oils, refer to Test Method D4006 (API MPMS Chapter 10.2).

Note 2With some types of oil, satisfactory results may be obtained from Test Method D1796 (API MPMS Chapter 10.6).

1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 6.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
2 Summary of Test Method
Significance and Use
Solvent-Carrier Liquid
Apparatus
TABLE 1
FIG. 1
3 Sampling
Verification
Procedure
FIG. 2
4 FIG. 3
TABLE 2
5 Calculation
Report
Precision and Bias
Keywords
TABLE 3
TABLE 4
ASTM-D95 2010
$40.63