ASTM-F373 2006(Redline)

This test method is designed to measure the vertical distance between any two levels on the face of the flooring, that is, between any two flat areas, between a flat area and any part of a textured area, or between two textured areas. This vertical distance may be of interest in itself or it may be applied to the questions of: ( 1 ) how much of the thickness of the flooring is available before the pattern is destroyed; or ( 2 ) how deep the depressed areas must be before valley printing ink is not walked on in normal traffic.

1. Scope

1.1 Two important characteristics involved in the manufacture of resilient flooring relate to the smoothness of the wear surface and the hardness of the layers under the wear surface. The surfaces may vary from completely textured areas to portions that are flat but separated by textured areas. This test method covers flooring with these interrupted wear surfaces which are not supported by soft, cushioned layers.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

Keywords

embossing; flooring; micrometer; resilient; texture;

ICS Code

ICS Number Code 97.150 (Non-textile floor coverings)

DOI: 10.1520/F0373-06 ASTM International is a member of CrossRef.

Citing ASTM Standards

[Back to Top]