ASTM-F400 2004

$44.96

F400-04 Standard Consumer Safety Specification for Lighters

Published By	Publication Date	Number of Pages
ASTM	2004	12

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F400-04

Historical Standard: Standard Consumer Safety Specification for Lighters

ASTM F400

Scope

1.1 This consumer safety specification covers all flame-producing consumer products commonly known as cigarette lighters, pipe lighters, and cigar lighters and such similar devices as defined in 2.1.7. Matches are specifically excluded from this safety specification; flame-producing products intended solely for igniting apparatus other than cigars, pipes, and cigarettes are also specifically excluded from this safety specification. Lighters are specifically not intended for use as a candle, flashlight, or for other uses requiring an extended burn time.

1.2 This specification establishes requirements for lighters to ensure a reasonable degree of safety for normal use or reasonably foreseeable misuse of such lighters by users.

1.3 Lighters, being flame-producing devices, can, as do all flame sources, present a potential hazard to the consumer. This specification cannot eliminate all hazards, but is intended to minimize potential hazards of lighters to users.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 The following precautionary caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

lighters

ICS Code

ICS Number Code 97.180 (Miscellanous domestic and commercial equipment)

DOI: 10.1520/F0400-04

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	General Requirements
3	TABLE 1
4	Structural Integrity Requirements
5	Refilling of Lighters Instructions and Warnings Test Methods
6	FIG. 1
9	Product Marking Keywords
10	A1. MANUFACTURERS’ ACCEPTABLE QUALITY LEVELS FOR SPECIFICATION AND INSET LIMITS FOR FLAME CHARACTERISTICS IN A1.1 A1.2 A1.3 A1.4 A1.5 A1.6 A1.7 A1.8 A2. MANUFACTURER’S REQUIREMENTS A2.1
11	X1. MANUFACTURERS’ SAMPLING SCHEME REFERENCES X1.1 X1.2 X1.3 X1.4 X1.5 X1.6 X2. TYPICAL TEST EQUIPMENT FIG. X2.1 FIG. X2.2
12	FIG. X2.3