ASTM-F7 2016
$35.75
F7-95(2016) Standard Specification for Aluminum Oxide Powder
| Published By | Publication Date | Number of Pages |
| ASTM | 2016 | 3 |
ASTM F7-95-Reapproved2016
Historical Standard: Standard Specification for Aluminum Oxide Powder
ASTM F7
Scope
1.1 This specification covers aluminum oxide (alumina) powder in two classes of particle size, two chemical grades, and two levels of acidity, for use as an insulating coating or as an ingredient of ceramic mixtures for components of electronic devices as follows:
1.1.1 Particle Sizes:
1.1.1.1 Class A—Particle size No. 500 nominal mesh (nominal average particle size = 24.3 μm).
1.1.1.2 Class B—Particle size No. 900 nominal mesh (nominal average particle size = 1.7 μm).
1.1.2 Chemical Grades—Grades 1 and 2 as specified under chemical requirements in Section 3.
1.1.3 Acidity Levels: pH (acid) 4.5 to 6.5 and pH (neutral) 6.5 to 7.5.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 The following safety hazards caveat pertains only to the test methods in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
alumina; particle sizing methods; powder ;
ICS Code
ICS Number Code 71.060.20 (Oxides)
DOI: 10.1520/F0007-95R16
Related products
-
ASTM-F763 2016
F763-04(2016) Standard Practice for Short-Term Screening of Implant Materials Published By Publication Date Number of…
-
ASTM-F748 2016
F748-16 Standard Practice for Selecting Generic Biological Test Methods for Materials and Devices Published By…
-
ASTM-F773M 2016
F773M-16 Standard Practice for Measuring Dose Rate Response of Linear Integrated Circuits (Metric) Published By…
-
ASTM-F744M 2016
F744M-16 Standard Test Method for Measuring Dose Rate Threshold for Upset of Digital Integrated Circuits…
-
ASTM-F748 2016(Redline)
F748-16 Standard Practice for Selecting Generic Biological Test Methods for Materials and Devices (Redline) Published…
-
ASTM-F76 2016
F76-08(2016) Standard Test Methods for Measuring Resistivity and Hall Coefficient and Determining Hall Mobility in…
-
ASTM-F76 2016
F76-08(2016)e1 Standard Test Methods for Measuring Resistivity and Hall Coefficient and Determining Hall Mobility in…
-
ASTM-F744M 2016(Redline)
F744M-16 Standard Test Method for Measuring Dose Rate Threshold for Upset of Digital Integrated Circuits…
-
ASTM-F724 2016
F724-94a(2016) Standard Test Method for Outdoor Evaluation of Tire Sidewall Component Cracking Resistance Published By…
-
ASTM-F773M 2016(Redline)
F773M-16 Standard Practice for Measuring Dose Rate Response of Linear Integrated Circuits (Metric) (Redline) Published…
