ASTM-F725 2013

$35.75

F725-03(2013) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards

Published By	Publication Date	Number of Pages
ASTM	2013	4

Guaranteed Safe Checkout

Categories: 23.040.20 - Plastics pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F725-03-Reapproved2013

Historical Standard: Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards

ASTM F725

Scope

1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.

1.2 This practice is applicable to thermoplastic pipe and fittings.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

drafting impact; drafting impact requirements; impact; plastic pipe; plastic tubing; thermoplastic pipe; thermoplastic tubing

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/F0725-03R13

Additional information

Standard Title	F725-03(2013) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
Published Code	ASTM
Publication Date	2013
Pages Count	4
ICS Codes	23.040.20 - Plastics pipes