ASTM-F725 2018
$29.79
F725-03(2018) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
| Published By | Publication Date | Number of Pages |
| ASTM | 2018 | 4 |
ASTM F725-03-Reapproved2018
Active Standard: Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
ASTM F725
Scope
1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.
1.2 This practice is applicable to thermoplastic pipe and fittings.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
drafting impact; drafting impact requirements; impact; plastic pipe; plastic tubing; thermoplastic pipe; thermoplastic tubing;
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/F0725-03R18
