ASTM-F959M 2007(Redline)

This specification covers the requirements for two types (Types 8.8 and 10.9) of compressible-washer-type direct tension indicators, in nominal diameter sizes M16 through M36, capable of indicating the achievement of a specified minimum bolt tension in a structural bolt and are intended for installation under either a bolt head or a hardened washer. Steel materials used in the manufacture of direct tension indicators shall be designed, processed, heat treated, and protectively coated as specified. The direct tension indicators shall conform to required chemical composition, compression load, outside diameter, number of protrusions, thickness values, inside diameter, and protrusion tangential diameter values.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt.

1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are covered:

1.2.1 Type 8.8 — direct tension indicators for use with Specification A 325M bolts, and

1.2.2 Type 10.9 — direct tension indicators for use with Specification A 490M bolts.

1.3 Direct tension indicators are intended for installation under either a bolt head or a hardened washer. (See Research Council on Structural Connections: Specification for Structural Joints Using ASTM A 325 or A 490 Bolts.)

1.4 The following precautionary statement pertains only to the test methods portions, Section 12, and Appendix X1 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A325M Specification for Structural Bolts, Steel, Heat Treated 830 MPa Minimum Tensile Strength (Metric) A490M Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural Steel Joints (Metric) B695 Specification for Coatings of Zinc Mechanically Deposited on Iron and Steel D3951 Practice for Commercial Packaging F436M Specification for Hardened Steel Washers (Metric) F606M Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, and Rivets (Metric) F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

Research Council on Structural Connections Standard

SpecificationforStru Available from Research Council on Structural Connections at www.boltcouncil.org.

Keywords

ompressible-washer-type; direct tension indicators; DTI; indicators; Compressible washer-type indicators; Direct tension indicators (DTI); Fasteners (metal) specifications; Indicators; Structural building materials/applications specifications; Structural fasteners; Tensile properties/testing metallic materials;

ICS Code

ICS Number Code 21.060.30 (Washers, locking elements)

DOI: 10.1520/F0959M-07 ASTM International is a member of CrossRef.

Citing ASTM Standards

[Back to Top]