🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
AWWA C210 2007

AWWA C210 2007

$75.83

AWWA C210-07: Liquid Epoxy Coating Systems For The Interior & Exterior Of Steel Water Pipelines

Published By Publication Date Number of Pages
AWWA 2007 28
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This standard sets minimum requirements for shop- and field-applied, liquid-epoxy exterior coatings and interior linings used in the potable-water-supply industry for steel water pipelines installed underground or underwater, under normal construction conditions. The coating systems described are not intended for use on pipe that will be bent after the coating or lining system has been applied. Unless specified otherwise by the purchaser, the coating and lining systems mayconsist of any of the following three types: a two-part, chemically cured epoxy primer and one or more coats of a different two-part, chemically cured epoxy topcoat; two or more coats of the same two-part, chemically cured epoxy coating, in which case the first coat shall be considered as the prime coat; or, a single coat of a two-part, chemically cured epoxy coating. All AWWA steel pipe coating standards are based on the maximum service temperature of potable water. The purpose of this standard is to provide the minimum requirements for liquid-epoxy coating systems for the interior and exterior of steel water pipelines, including material, application, inspection, testing, handling, and packaging requirements.

PDF Catalog

PDF Pages PDF Title
1 ANSI/AWWA C210-07
3 Committee Personnel
7 Contents
9 Foreword
I.
Introduction.
10 II. Special Issues.
11 III. Use of This Standard.
12 IV. Major Revisions.
V. Comments.
13 AWWA Standard Liquid-Epoxy Coating Systems
for the Interior and Exterior of
Steel Water Pipelines

Section 1:
General
Sec. 1.1
Scope
14 Sec. 1.2
Purpose
Sec. 1.3
Application
Section 2:
References
15 Section 3:
Definitions
16 Section 4:
Requirements
Sec. 4.1
Equipment
Sec. 4.2
Materials and Safety
Sec. 4.3
Coating System
17 Table 1.
Coated pipe inspection tests
Table 2.
Qualification requirements of laboratory-applied epoxy coating system
Sec. 4.4
Coating Application
20 Sec. 4.5
Coating Repair
Sec. 4.6
Welded Field Joints
21 Sec. 4.7
Coating Special Pipe Connections and Appurtenances
Sec. 4.8
Field Procedures
22 Section 5:
Verification
Sec. 5.1
Inspection and Testing
23 Sec. 5.2
Performance Testing of Laboratory-Applied Epoxy Coating System
24 Sec. 5.3
Rejection
Section 6:
Delivery
Sec. 6.1
Marking
Sec. 6.2
Packaging, Handling, Stacking, and Storage
25 Sec. 6.3
Affidavit of Compliance

Related products

AWWA C210 2007
$75.83