AWWA E103 2021

$76.92

AWWA E103-21 Horizontal Centrifugal and Vertical Line Shaft Pumps

Published By	Publication Date	Number of Pages
AWWA	2021	100

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard provides minimum requirements for horizontal centrifugal pumps and for vertical line-shaft pumps for installation in wells, water treatment plants, water transmission systems, and water distribution systems.

PDF Catalog

PDF Pages	PDF Title
7	Foreword I. Introduction. I.A. Background. This standard describes the minimum requirements for horizontal centrifugal pumps and for vertical line-shaft pumps for installation in wells, water treatment plants, water transmission systems, and water distribution systems. Pumps descr I.B. History. The original standard for vertical line-shaft turbine pumps presented the composite findings from studies conducted from 1949 to 1986 by committees consisting of manufacturers, consumers, and engineers. The first standard was published in 19
8	I.C. Acceptance. In May 1985, the US Environmental Protection Agency (USEPA) entered into a cooperative agreement with a consortium led by NSF International (NSF) to develop voluntary third-party consensus standards and a certification program for direct
9	II. Special Issues. II.A. Chlorine and Chloramine Degradation of Elastomers. The selection of materials is critical for water service and distribution piping in locations where there is a possibility that elastomers will be in contact with chlorine or chloramines. Documented II.B. Reliable Service. Users of horizontal centrifugal and vertical line-shaft pumps should not expect long-lasting or reliable service unless all aspects of the pump application are defined: operating conditions, environmental conditions, and local ambi
10	III. Use of This Standard. III.A. Purchaser Options and Alternatives. The following information should be provided in the purchase documents to further define the standard’s requirements:
11	IV. Modification to Standard. Any modification of the provisions, definitions, or terminology in this standard must be provided by the purchaser. VI. Comments. If you have any comments or questions about this standard, please contact Engineering and Technical Services at 303.794.7711; write to the department at 6666 West Quincy Avenue, Denver, CO 80235-3098; or email at [email protected].
13	AWWA Standard SECTION 1: GENERAL Sec. 1.1 Scope Sec. 1.2 Purpose Sec. 1.3 Application SECTION 2: REFERENCES
16	SECTION 3: DEFINITIONS
21	SECTION 4: REQUIREMENTS Sec. 4.1 Materials
22	Sec. 4.2 General Design: Common to Horizontal and Vertical Pumps
27	Sec. 4.4 General Design: Vertical Pumps
33	Sec. 4.5 Coatings
35	Sec. 4.6 Vibration Limits SECTION 5: VERIFICATION Sec. 5.1 Factory Tests Sec. 5.2 Data Provided by Manufacturer
36	SECTION 6: MARKING, PREPARATION FOR SHIPMENT, AND AFFIDAVIT Sec. 6.1 Marking Sec. 6.2 Packaging and Shipping
37	Sec. 6.3 Affidavit of Compliance
39	APPENDIX A Pump Cross Sections
77	Suggested Data Form for the Purchase of Vertical Line-Shaft Pumps
79	Engineering Information and Recommendations
85	Special issues for Consideration.