BS EN 10363:2016
$102.76
Continuously hot-rolled patterned steel strip and plate/sheet cut from wide strip. Tolerances on dimensions and shape
| Published By | Publication Date | Number of Pages |
| BSI | 2016 | 20 |
This European Standard specifies tolerances on dimensions and shape for continuously hot-rolled uncoated patterned steel strip and plate/sheet cut of it in nominal thicknesses up to 20 mm inclusive, of non-alloy and alloy steels in accordance with Table 1 (see also Annex A).
Table 1 — Field of application
a Usually these steel products are delivered in widths up to and including 2 200 mm. For widths values w over 2 200 mm, see 4.2, Option 4.
Steel grades other than those given in Table 1 may be used by agreement only.
This European standard does not apply to stainless steels.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Contents Page |
| 5 | European foreword |
| 6 | 1 Scope Table 1 — Field of application 2 Normative references 3 Terms and definitions 4 Information to be supplied by the purchaser 4.1 General |
| 7 | 4.2 Options 4.3 Example of designations |
| 8 | 5 Form of supply and design 5.1 Form of supply 5.2 Design |
| 9 | Figure 1 — Example of surface design T Figure 2 — Example of surface design R |
| 10 | Figure 3 — Example of surface design A 6 Tolerances for sheet/plate 6.1 Thickness Figure 4 — Height of pattern |
| 11 | Table 2 —Tolerances on thickness for strip and sheet/plate a 6.2 Width Table 3 — Tolerances on width for strip and sheet/plate 6.3 Length |
| 12 | Table 4 — Tolerances on length for sheet/plate 6.4 Flatness Table 5 — Tolerances on flatness for sheet/plate 6.5 Edge camber |
| 13 | 6.6 Out-of-squareness 6.7 Superimposement of dimensions 7 Tolerances for wide strip and strip slit from wide strip 7.1 General 7.2 Thickness 7.3 Width 7.4 Edge camber 8 Testing — Testing for dimensional accuracy 8.1 Extent of inspection 8.2 Test procedure 8.2.1 Thickness |
| 14 | 8.2.2 Width 8.2.3 Length of sheet/plate 8.2.4 Flatness Figure 5 — Determining of deviation from flatness 8.2.5 Edge camber 8.2.6 Out-of-squareness for sheet/plate |
| 15 | Figure 6 — Determining out-of squareness |
| 16 | Annex A (informative) Standards with steel grades for this dimensional standard |
| 17 | Annex B (informative) Indicative typical weight Table B.1 — Indicative typical weight |
| 18 | Bibliography |
