BS EN 17263:2019
$86.31
Copper and copper alloys. Eddy current testing on the outer surface of rods, bars, hollow rods and wires for the detection of defects by encircling test coil
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 14 |
This document specifies a procedure for fully automatic eddy current testing with no operator involvement with an encircling test coil for detecting defects on the surface of copper and copper alloy rods, bars, hollow rods and wires with a minimum diameter or width across flats defined in the relevant product standards. This test method can be continuous or discontinuous depending on the product. The product size range and test acceptance level are defined in the relevant product standards.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 5 | European foreword |
| 6 | Introduction |
| 7 | 1 Scope 2 Normative references 3 Terms and definitions 4 General requirements |
| 8 | 5 Personnel qualification 6 Eddy Current Test equipment 6.1 Test layout 6.1.1 Nominal frequency |
| 9 | 6.1.2 Test coil 6.2 Reference standard |
| 10 | 7 Calibration and Verification |
| 11 | 8 Acceptance criteria 8.1 Detection of single local discontinuity by encircling coil systems 8.2 Detection of several local surface effects by encircling coil systems by using low signal amplitudes as detection threshold |
| 12 | 9 Other methods 10 Documentation |
| 13 | Bibliography |
