🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BS EN 485-1:2016

BS EN 485-1:2016

$102.76

Aluminium and aluminium alloys. Sheet, strip and plate – Technical conditions for inspection and delivery

Published By Publication Date Number of Pages
BSI 2016 22
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This document specifies the technical conditions for inspection and delivery of wrought aluminium and wrought aluminium alloy sheet, strip and plate for general applications. It also includes provisions for ordering and testing.

It applies to products with a thickness over 0,20 mm up to and including 400 mm.

For many special applications of aluminium strip, sheet and plate, specific European Standards exist, where different or additional requirements are formulated and the appropriate alloys and tempers are selected: see Annex A. Most of these special European Standards refer to provisions of this document.

The selection of the relevant special European Standards is under the responsibility of the purchaser.

Whenever the application involves special properties, such as corrosion resistance, toughness, fatigue strength, surface appearance and welding properties, the user should consult the supplier and consider the relevant special European Standard, as applicable.

PDF Catalog

PDF Pages PDF Title
4 Contents Page
5 European foreword
6 1 Scope
2 Normative references
8 3 Terms and definitions
4 Ordering information
10 5 Requirements
5.1 Responsibilities of the supplier and manufacturer
5.2 Requirements on product properties
5.2.1 Chemical composition
5.2.2 Mechanical properties
5.2.3 Corrosion behaviour
5.2.4 Freedom from defects
11 5.2.5 Tolerances on dimensions and form
6 Test methods
6.1 General
6.2 Chemical analysis
6.3 Tensile test
6.3.1 General
12 6.3.2 Number of specimens
6.3.3 Location and size of specimens
6.3.4 Identification
6.3.5 Shape, dimensions and orientation of test pieces
13 6.3.6 Machining of test pieces
6.3.7 Number of test pieces
6.3.8 Procedure
6.4 Bend test
14 Figure 1 — Standard rectangular tensile test piece
15 Figure 2 — Standard 10 mm tensile test piece with 50 mm gauge length and examples of small size proportional test pieces
6.5 Hardness test
16 Table 1 — Minimum material thickness and Brinell hardness values
6.6 Electrical conductivity
6.7 Dimensions
6.8 Surface finish
6.9 Stress corrosion resistance
17 6.10 Exfoliation and inter-granular corrosion resistance (5xxx and 7xxx series alloys)
6.10.1 5xxx alloys
6.10.2 7xxx series alloys
6.11 Other tests
6.12 Retest
6.12.1 Mechanical properties
18 6.12.2 Other properties
7 Inspection document
8 Marking of products
9 Packaging
10 Complaints of non conformity
19 Annex A (normative) European Standards for strip, sheet and plate of special form and for special applications
Table A.1 — European Standards for strip, sheet and plate of special form and for special applications
20 Bibliography

Related products

BS EN 485-1:2016
$102.76