BS EN 61169-41:2011
$167.15
Radio-frequency connectors – Sectional specification for CQA series quick lock R.F. coaxial connectors
| Published By | Publication Date | Number of Pages |
| BSI | 2011 | 38 |
IEC 61169-41:2011 provides information and rules for preparation of detail specification of CQA series quick lock R.F. coaxial connectors together with the pro-forma blank detail specification. It also prescribes mating face dimensions for general connectors – grade 2, dimensional detail of standard test connectors – grade 0, gauging information and tests selected from IEC 61169-1 applicable to all detail specifications relating to CQA series RF connectors. It indicates recommended performance characteristics to be considered when writing a detail specification and it covers test schedules and inspection requirements for assessment levels M and H. It cancels and replaces IEC/PAS 61169-41, published in 2009, of which it constitutes a minor revision. The only change is that the PAS has been changed into and International Standard. The French version of this standard has not been voted upon.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 8 | FOREWORD |
| 10 | INTRODUCTION |
| 11 | 1 Scope 2 Normative references |
| 12 | 3 Mating face and gauge information 3.1 Dimensions – General connectors – Grade 2 Figures Figure 1 – Connector with pin-centre contact (for dimensions and notes, see Table 1) |
| 13 | Tables Table 1 – Dimensions of connector with pin-centre contact |
| 14 | Figure 2 – Connector with socket-centre contact (for dimensions and notes, see Table 2) |
| 15 | Table 2 – Dimensions of connector with socket-centre contact |
| 16 | 3.2 Gauges Figure 3 – Gauge pins for socket-centre contact (for dimensions and notes, see Table 3) Table 3 – Dimensions of gauge pins for socket-centre contact |
| 17 | Figure 4 – Gauge pins for outer contact(for dimensions and notes, see Table 4) Table 4 – Gauge pins for outer contact |
| 18 | 3.3 Dimensions – Standard test connectors – Grade 0 Figure 5 – Connector with pin-centre contact (for dimensions and notes, see Table 5) |
| 19 | Table 5 – Dimensions of connector with pin-centre contact |
| 20 | Figure 6 – Connector with socket-centre contact (for dimensions and notes, see Table 6) |
| 21 | 4 Quality assessment procedure 4.1 General 4.2 Rating and characteristics (see Clause 6 of IEC 61169-1) Table 6 – Dimensions of connector with socket-centre contact |
| 22 | Table 7 – Rating and characteristics |
| 25 | 4.3 Test schedule and inspection requirements – Acceptance tests Table 8 – Acceptance tests |
| 26 | Table 9 – Periodic tests |
| 28 | 4.4 Procedures 5 Instructions for preparation of detail specifications 5.1 General 5.2 Identification of the component |
| 29 | 5.3 Performance 5.4 Marking, ordering information and related matters 5.5 Selection of tests, test conditions and severities |
| 30 | 5.6 Blank detail specification pro-forma for type CQA connector |
| 35 | Annex A (normative) Adjunct for SMA intermateability Figure A.1 – Adjunct (for dimensions and notes, see Table A.1) |
| 36 | Table A.1 – Dimensions of adjunct |
