BS EN IEC 60034-14:2018
$142.49
Rotating electrical machines – Mechanical vibration of certain machines with shaft heights 56 mm and higher. Measurement, evaluation and limits of vibration severity
| Published By | Publication Date | Number of Pages |
| BSI | 2018 | 24 |
This part of IEC 60034 specifies the factory acceptance vibration test procedures and vibration limits for certain electrical machines under specified conditions, when uncoupled from any load or prime mover.
It is applicable to DC and three-phase AC machines, with shaft heights 56 mm and higher and a rated output up to 50 MW, at operational speeds from 120 min -1 up to and including 15 000 min -1 .
This document is not applicable to machines mounted in situ (on site), three-phase commutator motors, single-phase machines, three-phase machines operated on single-phase systems, vertical waterpower generators, turbine generators greater than 20 MW and machines with magnetic bearings or series-wound machines.
For machines measured in situ, refer to applicable parts of ISO 20816 , ISO 10816 and ISO 7919 .
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | undefined |
| 5 | Annex ZA(normative)Normative references to international publicationswith their corresponding European publications |
| 7 | English CONTENTS |
| 9 | FOREWORD |
| 11 | 1 Scope 2 Normative references 3 Terms and definitions |
| 12 | 4 Measurement quantities 4.1 General 4.2 Vibration magnitude 4.3 Relative shaft vibration 5 Measurement equipment |
| 13 | 6 Machine mounting 6.1 General 6.2 Free suspension 6.3 Rigid mounting 6.3.1 Foundation |
| 14 | 6.3.2 Horizontal machines 6.3.3 Vertical machines 6.4 Active environment determination |
| 15 | 7 Conditions of measurement 7.1 Key 7.2 Measurement positions and directions 7.2.1 Measurement positions for vibration 7.2.2 Measurement positions for relative shaft displacement 7.3 Test conditions 7.4 Vibration transducer |
| 16 | 8 Limits of bearing housing vibration 8.1 Limits of vibration magnitude Tables Table 1 – Limits of maximum vibration magnitude in displacement (r.m.s.) and velocity (r.m.s.) for shaft height H |
| 17 | 8.2 Limits of vibration velocity with twice-line frequency for a.c. machines 8.3 Axial vibration 9 Limits of relative shaft vibration |
| 18 | Figures Figure 1 – Minimum elastic displacement as a function of rated speed Table 2 – Limits for the maximum shaft vibration (Sp-p) andthe maximum run-out |
| 19 | Figure 2 – Preferred positions of measurement applicable to one or both ends of the machine Figure 3 – Measurement positions for those ends of machines where measurements according to Figure 2 are not possible without disassembly of parts |
| 20 | Figure 4 – Measurement positions for pedestal bearing Figure 5 – Preferred circumferential position of transducers for the measurement of relative shaft displacement |
| 21 | Figure 6 – Measurement positions for vertical machines (measurements to be madeat the bearing housing; when not accessible, then as close as possible) |
| 22 | Figure 7 – Vibration limit diagram for shaft heights H > 132 mm |
| 23 | Bibliography |
Related products
-
BS EN IEC 60034-14:2018 – TC:2020 Edition
Tracked Changes. Rotating electrical machines – Mechanical vibration of certain machines with shaft heights 56…
