🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BS EN IEC 61076-2-011:2021

BS EN IEC 61076-2-011:2021

$102.76

Connectors for electrical and electronic equipment. Product requirements – Circular connectors. Detail specification for B12 bayonet coupling connectors based on mating interfaces according to IEC 61076-2-101 and IEC 61076-2-109

Published By Publication Date Number of Pages
BSI 2021 18
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

IEC 61076-2-011:2021 describes the bayonet coupling interface of circular connectors that are typically used for industrial process measurement and control. These connectors consist of fixed and free connectors either rewireable or non-rewireable, with bayonet-coupling. These connectors may have glass to metal seal inserts. They have male or female contacts and are deemed to be intermateable with corresponding free connectors produced according to this document. Male connectors have round contacts Ø 0,6 mm, Ø 0,76 mm, Ø 0,8 mm and Ø 1,0 mm. Different codings prevent the mating of these individually coded fixed connectors (and consequently of individually coded free connectors deemed to couple with them) to other interfaces and cross-mating between the different codings. However, the styles and interface dimensions, except for the coupling mechanism, are as given in 4.3 of IEC 61076-2- 101:2012 and 4.3.1 of IEC 61076-2-109:2014. The male type B12 circular connectors are interoperable with the female type B12 connector of the same coding and ways. The female type B12 connectors are interoperable with the male type B12 and M12 (threaded screw coupling) connector of the same coding and ways.

PDF Catalog

PDF Pages PDF Title
2 undefined
5 Annex ZA (normative)Normative references to international publicationswith their corresponding European publications
7 English
CONTENTS
8 FOREWORD
10 INTRODUCTION
11 1 Scope
2 Normative references
12 3 Terms and definitions
4 Technical information
4.1 Recommended method of termination
4.1.1 General
4.1.2 Number of contacts or contact cavities
4.2 Ratings and characteristics
4.3 Marking
4.4 Safety aspects
5 Dimensions
5.1 General
5.2 Survey of styles and variants
13 5.3 Interface dimensions for connectors
5.3.1 Interface dimensions for fixed connector
Figure 1 – Coupling dimensions for fixed connectors
14 5.3.2 Interface dimensions for free connector
Figure 2 – Coupling dimensions for free cable connectors
Table 1 – Coupling dimensions, fixed connector
Table 2 – Coupling dimensions, free cable connector
15 5.3.3 Pin front view of connectors and contact position
5.4 Engagement (mating) information
6 Characteristics
6.1 Climatic category
6.2 Mechanical
7 Test schedule
16 Annex A (informative)Diameter of the female connector body
17 Annex B (informative)Contact and pair designation for balanced cabling

Related products

BS EN IEC 61076-2-011:2021
$102.76