BS EN ISO 19066-1:2014
$102.76
Plastics. Methyl methacrylate-acrylonitrile-butadiene-styrene (MABS) moulding and extrusion materials – Designation system and basis for specifications
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 18 |
This part of ISO 19066 establishes a system of designation for methyl methacrylate-acrylonitrile-butadiene-styrene (MABS) moulding and extrusion materials, which can be used as the basis for specifications.
The types of MABS plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties
-
Vicat softening temperature,
-
melt volume-flow rate,
-
Charpy notched impact strength, and
-
tensile modulus,
and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers, and reinforcing materials.
This part of ISO 19066 is applicable to all methyl methacrylate-acrylonitrile-butadiene-styrene materials consisting of a continuous phase based mainly on copolymers of styrene (and/or an alkyl-substituted styrene), acrylonitrile and methyl methacrylate, and a dispersed elastomeric phase based on butadiene.
It applies to MABS materials ready for normal use in the form of powder, granules, or pellets, unmodified or modified by colorants, additives, fillers, etc.
It is not intended to imply that materials having the same designation give necessarily the same performance. This part of ISO 19066 does not provide engineering data, performance data, or data on processing conditions which might be required to specify a material for a particular application and/or method of processing.
If such additional properties are required, they will be determined in accordance with the test methods specified in ISO 10366-2, if suitable.
In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements can be given in data block 5 (see 3.1).
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 1 Scope 2 Normative references |
| 10 | Section sec_3 Section sec_3.1 Section sec_3.2 Table tab_1 3 Designation system 3.1 General 3.2 Data block 1 |
| 11 | Section sec_3.3 Table tab_2 Section sec_3.4 3.3 Data block 2 3.4 Data block 3 |
| 12 | Table tab_3 Section sec_3.5 Section sec_3.5.1 Section sec_3.5.2 3.5 Data block 4 |
| 13 | Table tab_4 Section sec_3.5.3 Table tab_5 Section sec_3.5.4 Table tab_6 Section sec_3.5.5 |
| 14 | Table tab_7 Section sec_3.6 Section sec_4 3.6 Data block 5 4 Example of a designation |
Related products
-
ISO 19066-1:2014
Plastics — Methyl methacrylate-acrylonitrile-butadiene-styrene (MABS) moulding and extrusion materials — Part 1: Designation system and…
