BS EN ISO 19932-2:2013
$167.15
Equipment for crop protection. Knapsack sprayers – Test methods
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 34 |
This part of ISO 19932 specifies test methods for the verification of requirements of ISO 19932-1 for knapsack sprayers carried on the back or shoulder of the operator for use with plant protection products.
It is applicable to lever-operated knapsack sprayers, knapsack compression sprayers and knapsack sprayers driven by an engine or electric motor using hydraulic pressure atomization of the spray liquid, with a nominal volume of more than 3 l for their intended use primarily in agriculture and horticulture.
It does not apply to knapsack mistblowers covered by ISO 28139.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 5 | Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC on machinery and Directive 2009/127/EC amending Directive 2006/42/EC with regard to machinery for pesticide application |
| 7 | Foreword |
| 8 | Introduction |
| 10 | Section sec_1 Section sec_2 Section sec_3 Section sec_4 Section sec_4.1 Section sec_4.2 Section sec_4.3 Section sec_4.4 1 Scope 2 Normative references 3 Terms and definitions 4 Test liquids and equipment |
| 11 | Section sec_4.5 Section sec_4.6 Section sec_4.7 Section sec_4.8 Section sec_4.9 Section sec_4.10 Section sec_4.11 Section sec_4.12 Section sec_4.13 Section sec_5 Section sec_5.1 Section sec_5.2 Section sec_5.3 Section sec_5.3.1 Section sec_5.3.2 5 General 5.1 Test conditions 5.2 Sprayer 5.3 Functional tests |
| 12 | Section sec_5.3.3 Section sec_5.3.4 Section sec_5.3.5 |
| 13 | Section sec_5.3.6 Section sec_5.3.7 Section sec_5.3.8 |
| 14 | Section sec_5.3.9 Section sec_5.4 5.4 Pressure test |
| 15 | Section sec_5.5 Section sec_5.6 5.5 Leakage test 5.6 Centre of gravity |
| 16 | Table tab_e Figure fig_1 Section sec_6 Section sec_6.1 Section sec_6.1.1 6 Specific tests for lever-operated knapsack sprayers 6.1 Preconditioning |
| 17 | Section sec_6.1.2 Section sec_6.1.3 Section sec_6.2 6.2 Drop test |
| 18 | Section sec_7 Section sec_7.1 Section sec_7.2 7 Specific tests for engine- or motor-driven knapsack sprayers 7.1 Volume of external surface deposit 7.2 Volume of total residual liquid |
| 19 | Section sec_8 Section sec_8.1 Section sec_8.1.1 Section sec_8.1.2 8 Specific tests for compression sprayers 8.1 Volume test |
| 20 | Section sec_8.2 Section sec_9 8.2 Drop test 9 Test report |
| 21 | Annex sec_A Table tab_f Figure fig_A.1 Annex A (informative) Example of a preconditioning device |
| 22 | Annex sec_B Table tab_g Figure fig_B.1 Annex B (informative) Example of a shut-off test device |
| 23 | Annex sec_C Table tab_h Figure fig_C.1 Annex C (informative) Example of a strap test device |
| 24 | Annex sec_D Table tab_i Figure fig_D.1 Annex D (informative) Example of drop test device |
| 25 | Annex sec_E Table tab_j Figure fig_E.1 Annex E (informative) Example of filling device |
| 26 | Annex sec_F Annex F (normative) Minimum content of test report |
