BS EN ISO 294-1:1998:2002 Edition
$142.49
Plastics. Injection moulding of test specimens of thermoplastic materials – General principles, and moulding of multipurpose and bar test specimens
| Published By | Publication Date | Number of Pages |
| BSI | 2002 | 26 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | BRITISH STANDARD |
| 2 | National foreword |
| 3 | Short contents |
| 6 | Foreword Foreword to amendment A1 |
| 11 | Introduction 1 Scope 2 Normative references |
| 12 | 3 Definitions 3.1 mould temperature, 3.2 melt temperature, 3.3 melt pressure, 3.4 hold pressure, 3.5 moulding cycle 3.6 cycle time, |
| 13 | Figure 1 Schematic diagram of an injection-moulding cycle, showing the melt pressure (full line) and the l… 3.7 injection time, 3.8 cooling time, 3.9 hold time, 3.10 mould-open time, 3.11 cavity |
| 14 | 3.12 single-cavity mould 3.13 multi-cavity mould 3.14 family mould 3.15 ISO mould 3.16 critical cross-sectional area, 3.17 moulding volume, 3.18 projected area, 3.19 locking force, |
| 15 | 3.20 injection velocity, 3.21 shot capacity, 4 Apparatus 4.1 Moulds |
| 18 | 4.2 Injection-moulding machine Figure 4 Examples of single-cavity moulds |
| 19 | Figure 5 Example of a family mould |
| 20 | 5 Procedure 5.1 Conditioning of material 5.2 Injection moulding 5.3 Measurement of mould temperature 5.4 Measurement of the melt temperature |
| 21 | 5.5 Post-moulding treatment of test specimens 6 Report on test-specimen preparation |
| 22 | Annex A (informative) Examples of runner configurations Figure A.1 Different types of runner configuration |
| 23 | Annex B (informative) Standardized injection-moulding mould components |
| 24 | Annex C (informative) Example of an injection mould Figure C.1 Exploded view of an injection mould with an interchangeable two cavity plate for a type A ISO mould |
| 25 | Annex ZA (normative) Normative references to international publications with their relevant European publi… Normative references to international publications with their relevant European publi… |
