BS ISO 12164-4:2014
$102.76
Hollow taper interface with flange contact surface – Dimensions of receivers for stationary tools
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 16 |
This part of ISO 12164 specifies dimensions for receivers with taper and flange contact surfaces for hollow taper shanks in accordance with ISO 12164-3 to be applied to machine tools (e.g. turning machines, turning-mill machines). A range of sizes is specified.
This part of ISO 12164 specifies the receiver of type T. It is for automatic tool exchange and manual clamping, which is achieved via holes in both the receiver and the tool shank.
The torque is transmitted via the tail end of the shank through keys as well as friction.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.2 1 Scope 2 Normative references 3 Dimensions 3.1 General 3.2 Receiver for hollow taper shank, type T |
| 8 | Table tab_a Figure fig_1 |
| 9 | Table tab_1 Section sec_4 Section sec_5 4 Design — Hole for manual clamping 5 Designation |
| 11 | Annex sec_A Annex sec_A.1 Annex sec_A.2 Table tab_A.1 Annex sec_A.3 Annex A (informative) Recommendations for use and application |
| 12 | Reference ref_1 Bibliography |
