BS ISO 12482:2014
$142.49
Cranes. Monitoring for crane design working period
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 24 |
This International Standard specifies a method for monitoring, during long-term operation, the actual duty of the crane, and a means of comparing this to the original design duty which was specified through classification. The related design standard is ISO 4301-1. Approaching the design life limit means an increased probability of hazards. Monitoring of crane use — as described herein — provides a tool for predicting the approach of the design limits and for focusing special inspections on the critical areas of a crane.
This International Standard is intended to be used for adjusting/modifying the inspections defined in ISO 9927-1.
It is applicable to cranes with a permanent construction throughout the life of the crane.
It is not applicable to mobile or tower cranes, except permanently installed tower cranes.
NOTE The method specified in this International Standard can be adapted to standards or rules other than ISO 4301-1 which specify classifications.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.2 Section sec_3.3 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | Section sec_3.4 Section sec_3.5 Section sec_3.6 Section sec_4 Section sec_4.1 Section sec_4.2 4 Recording crane operation 4.1 General 4.2 Methods for counting duty |
| 11 | Section sec_4.3 Table tab_1 Section sec_5 Section sec_5.1 Section sec_5.2 Section sec_5.3 4.3 Safety factor for duty counting 5 Assessment of design working period 5.1 General 5.2 Schedule 5.3 DWP calculation method |
| 12 | Section sec_6 Section sec_6.1 Section sec_6.2 Section sec_6.3 6 Special assessment 6.1 General 6.2 Criteria for special assessment 6.3 Responsibilities of crane user/owner |
| 13 | Section sec_6.4 Section sec_6.5 Section sec_7 Section sec_7.1 Section sec_7.2 6.4 Manufacturer’s instructions 6.5 Report 7 General overhaul (GO) 7.1 General 7.2 Categories of actions |
| 14 | Table tab_a Figure fig_1 |
| 15 | Annex sec_A Annex sec_A.1 Annex sec_A.2 Table tab_A.1 Annex A (normative) DWP calculation for cranes designed to ISO 4301‑1 |
| 16 | Annex sec_A.3 Table tab_A.2 |
| 17 | Annex sec_A.4 |
| 18 | Annex sec_B Annex sec_B.1 Annex sec_B.2 Table tab_B.1 Annex B (normative) DWP calculation for hoisting mechanisms designed to ISO 4301‑1 |
| 19 | Table tab_B.2 Annex sec_B.3 |
| 20 | Table tab_B.3 |
| 21 | Reference ref_1 Reference ref_2 Reference ref_3 Bibliography |
