BS ISO 20898:2008 2009
$142.49
Industrial trucks. Electrical requirements
| Published By | Publication Date | Number of Pages |
| BSI | 2009 | 28 |
This International Standard specifies the electrical requirements for the design and manufacture of self-propelled industrial trucks including masted and variable reach rough terrain trucks (see ISO 5053:1987, 3.1.3.1.8), and tow tractors with a rated drawbar pull up to and including 20 000 N. This International Standard applies to trucks with battery voltages in accordance with ISO 1044. For additional requirements of trucks with mains power, see IEC 60204-1.
This International Standard does not apply to
-
trucks used in potentially explosive atmospheres, or
-
issues related to electromagnetic compatibility.
This International Standard does not repeat all the technical rules which are state of the art and which are applicable to the material used to construct the industrial truck, for which reference can be made to ISO 12100-2.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 7 | Scope Normative references |
| 8 | Terms and definitions |
| 9 | List of hazards |
| 11 | Requirements Electrical requirements for battery powered trucks Traction batteries |
| 12 | Battery leads Battery connectors |
| 13 | Battery charging Emergency switching off requirements (disconnection) connect Design construction |
| 14 | Trucks with nominal battery voltage exceeding 120 V dc Wiring and wire construction |
| 15 | Electrical Shock Protection [direct contact and indirect con Lamps and lampholders Slack/broken chains Low voltage Overcurrent protective devices |
| 16 | Controls — General Controls — Travel Controls — Load handling Control — Steering Contactors |
| 17 | Truck testing Electrical requirements for internal combustion trucks Battery Circuit protection Control systems |
| 18 | Wiring and wire construction Electrical shock protection [direct contact and indirect con Verification of battery powered trucks Insulation resistance testing (routine test) |
| 19 | Type testing Abnormal operation Temperature Arc rupture Dielectric test |
| 20 | Battery connector testing |
| 21 | Contactor testing Verification of making and breaking capacities in proving op |
| 22 | Verification of rated making and breaking capacities of inte Verification of operating limits Drop out voltage Information for use Minimum markings for electric trucks Wire, cables and terminals |
| 23 | Battery connectors Batteries Maintenance, charging and handling Battery compartment and electrical enclosures Electrical diagram Safety checks Charging area Charging in truck |
| 24 | Charging in a designated area Minimum marking internal combustion trucks Wires, cables and terminals Electrical diagram Safety checks |
