BS ISO 6932:2014
$142.49
Cold-reduced carbon steel strip with a maximum carbon content of 0,25 %
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 24 |
This International Standard describes cold-reduced carbon steel strip with a maximum mass fraction of carbon of 0,25 %, furnished to two levels of closer tolerances than cold-reduced carbon steel sheet, with specific quality, specific hardness requirements or mechanical properties, specific edge, and specific finish.
NOTE This International Standard does not apply to the product in narrow widths known as cold-reduced carbon steel sheet slit from wider widths (see ISO 3574), nor does it include cold-reduced carbon steel strip with a mass fraction of carbon over 0,25 % (see ISO 4960).
Cold-reduced carbon steel strip is produced with a maximum mass fraction of the specified carbon not exceeding:
-
0,15 % for material specified to mechanical properties;
-
0,25 % for material specified to temper (hardness) requirements.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.2 Section sec_3.3 1 Scope 2 Normative references 3 Terms and definitions |
| 8 | Section sec_3.4 Section sec_3.5 Section sec_3.6 Section sec_3.7 Section sec_3.8 Section sec_3.9 Section sec_4 Section sec_5 Section sec_5.1 Section sec_5.2 Section sec_5.3 4 Dimensions 5 Chemical composition 5.1 General 5.2 Heat analysis 5.3 Product analysis |
| 9 | Table tab_1 Table tab_2 Table tab_3 |
| 10 | Section sec_6 Section sec_6.1 Section sec_6.1.1 Section sec_6.1.2 Section sec_6.1.3 Section sec_6.2 6 Conditions of manufacture 6.1 Physical properties 6.2 Steelmaking |
| 11 | Table tab_4 |
| 12 | Table tab_5 |
| 13 | Section sec_6.3 Section sec_6.4 Section sec_6.5 Section sec_6.5.1 Section sec_6.5.2 Section sec_6.6 Section sec_6.7 6.3 Weldability 6.4 Application 6.5 Mechanical properties 6.6 Oiling 6.7 Edges |
| 14 | Section sec_6.8 Section sec_7 Table tab_6 6.8 Surface finish 7 Dimensional and shape tolerances |
| 15 | Table tab_7 Table tab_8 |
| 16 | Table tab_9 Table tab_10 Table tab_11 |
| 17 | Table tab_a Figure fig_1 Section sec_8 Section sec_9 Section sec_9.1 Section sec_9.2 8 Sampling — Hardness or tensile test 9 Mechanical property tests 9.1 Hardness test 9.2 Tensile test |
| 18 | Section sec_10 Section sec_10.1 Section sec_10.2 Section sec_11 Section sec_12 Section sec_13 Section sec_14 Section sec_15 10 Retests 10.1 Machining and flaws 10.2 Additional tests 11 Resubmission 12 Workmanship 13 Inspection and acceptance 14 Coil size 15 Marking |
| 19 | Section sec_16 16 Information to be supplied by the purchaser |
| 20 | Reference ref_1 Reference ref_2 Reference ref_3 Reference ref_4 Reference ref_5 Bibliography |
