🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BSI PAS 70:2003

BSI PAS 70:2003

$83.57

HD clay bricks. Guide to appearance and site measured dimensions and tolerance

Published By Publication Date Number of Pages
BSI 2003 14
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This Publicly Available Specification gives guidance on assessing the appearance of facing bricks, and the determination of on-site measurements of work size dimensions, for all high density (HD) type clay bricks as defined by BS EN 771-1.

It includes a procedure for comparing sample panels with reference panels in order to assess the appearance acceptability of consignments of clay facing bricks. It is not intended to apply to common and engineering HD type clay bricks.

It also provides a method of determining the overall dimensions of all clay bricks. The limits for the tolerance categories for the mean and range are those that apply to HD type clay bricks where the manufacturer’s declared work sizes are those traditionally known as British Standard dimensions (UK standard format clay bricks). If clay bricks are supplied with other work sizes, the limits for these categories will need to be calculated in accordance with BS EN 771-1.

PDF Catalog

PDF Pages PDF Title
1 PUBLICLY AVAILABLE SPECIFICATION
3 Contents
5 Introduction
1 Scope
2 Normative references
3 Terms and definitions
3.1 brickwork
6 3.2 HD (high density) clay brick
3.3 brick
3.4 facing unit
3.5 common unit
3.6 engineering brick
3.7 recessed joint
3.8 flush joint
3.9 reference panel
3.10 sample panel
4 Appearance
4.1 General
7 4.2 Principle
4.3 Construction of the reference panel
4.4 Construction of the sample panels
8 4.5 Assessment
5 Dimensions and tolerances
5.1 Principle
5.2 Apparatus
5.3 Preparation of specimens
5.4 Procedure A — Tolerances for mean dimensions (T1, T2 or Tm)
Figure 1 – Arrangement of bricks for measurement of dimension
9 Table 1 – Tolerance category criteria
5.5 Procedure B — Tolerance category for dimensional range (R1, R2 and Rm)
Figure 2 – Brick measurement positions
10 Table 2 – Range category criteria
5.6 Practical considerations of Procedures A and B
5.7 Test report
11 Annex A (informative) Example report format for Procedure B

Related products

BSI PAS 70:2003
$83.57