Shopping Cart

No products in the cart.

IEEE 1160-1993

$94.25

IEEE Standard Test Procedures for High-Purity Germanium Crystals for Radiation Detectors

Published By Publication Date Number of Pages
IEEE 1993 36
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

New IEEE Standard – Inactive-Reserved. This standard applies to the measurement of bulk properties of high-purity germanium as they relate to fabrication and performance of germanium detectors for gamma rays and x rays. Such germanium is monocrystalline and has a net concentration of fewer than 1011 electrically active impurity center per cm3, usually on the order of 1010 cm-3.

PDF Catalog

PDF Pages PDF Title
1 Title Page
3 Introduction
5 CONTENTS
7 1. Overview
1.1 Scope
1.2 Purpose
8 2. References
3. Letter symbols
9 4. Introduction
10 5. Sample preparation and measurement of net electrically active impurity concentration |NA ā€“ ND|
5.1 Sample preparation for van der Pauw measurements
12 5.2 Measurement and analysis
17 5.3 Spatial dependence of (NA ā€“ ND)
19 6. Deep-level transient spectroscopy (DLTS) for the characterization of point-defect trapping cen…
20 6.1 Equipment
21 6.2 Sample selection and preparation for DLTS
6.3 Measurement procedure
25 6.4 Majority-carrier deep levels in p-type HPGe
26 6.5 Majority-carrier deep levels in n-type HPGe
6.6 Reporting
7. Crystallographic properties
7.1 Crystallographic orientation
7.2 Sample preparation
28 7.3 Reporting
8. Bibliography
30 Annex A
IEEE 1160-1993
$94.25