IEEE 1668-2014
$80.71
IEEE Trial-Use Recommended Practice for Voltage Sag and Short Interruption Ride-Through Testing for End-Use Electrical Equipment Rated Less than 1000 V
Published By | Publication Date | Number of Pages |
IEEE | 2014 |
New IEEE Standard – Superseded. A trial-use, non-industry-specific recommended practice for voltage sag and short interruption ride-through performance and compliance testing for all electrical and electronic equipment connected to low-voltage power systems that can experience malfunction or shutdown as a result of reductions in supply voltage lasting less than one minute is detailed in this document. Testing procedures and requirements for test equipment are clearly defined within this document to reflect this electrical environment, including single-phase, two-phase, and three-phase balanced and unbalanced voltage sags. Requirements for certification and test reporting, including characterization of voltage-sag ride-through equipment are also defined.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 1668™-2014 Front Cover |
3 | Title page |
5 | Important Notices and Disclaimers Concerning IEEE Standards Documents |
8 | Participants |
10 | Introduction |
11 | Contents |
13 | Important Notice 1. Overview 1.1 Scope |
14 | 1.2 Purpose 1.3 Limitations 2. Normative references |
15 | 3. Definitions and acronyms 3.1 Definitions |
17 | 3.2 Acronyms 4. A primer on voltage sags 4.1 Background on voltage sags |
18 | 4.2 The basics of voltage sags |
21 | 4.3 Other key voltage-sag characteristics |
25 | 4.4 Faults and voltage sags |
36 | 4.5 Voltage sags and current relationships 4.6 How common are voltage sags? |
45 | 4.7 Other causes and effects of voltage sags |
46 | 5. Recommended voltage-sag test requirements 5.1 Background on test requirements 5.2 Classification of votage-sag types in three-phase systems |
49 | 5.3 Recommended voltage-sag immunity levels |
56 | Annex A (informative) Test procedures and guidelines A.1 Considerations and guidance on test vector |
58 | A.2 Safety precautions for voltage-sag testing |
59 | A.3 Test setup |
62 | A.4 Compliance test procedures |
66 | A.5 Voltage-sag immunity characterization test procedures |
87 | Annex B (normative) Test equipment requirements |
88 | Annex C (normative) Certification and test reports C.1 Certificates C.2 Test reports |
90 | Annex D (informative) Bibliography |