IEEE C50.13-2014

$62.83

IEEE Standard for Cylindrical-Rotor 50 Hz and 60 Hz Synchronous Generators Rated 10 MVA and Above

Published By	Publication Date	Number of Pages
IEEE	2014

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Revision Standard – Active. The requirements in this standard are applied to 50 Hz and 60 Hz, two-pole and four pole, cylindrical-rotor synchronous generators driven by steam turbines and/or by combustion gas turbines. The drive may be direct or through a gearbox or other device that permits different speeds for the turbine and the generator. The generators covered by this standard are to have rated outputs of 10 MVA and above.

PDF Catalog

PDF Pages	PDF Title
1	IEEE Std C50.13-2014 Front Cover
3	Title Page
5	Important Notices and Disclaimers Concerning IEEE Standards Documents
8	Participants
10	Introduction
12	Contents
15	Important Notice 1. Overview 1.1 Scope 1.2 Purpose
16	2. Normative references
17	3. Definitions
18	4. Operational requirements 4.1 Service conditions and steady-state duty
26	4.2 Transient event and emergency duty requirements
32	4.3 Service environment
33	5. Rating and performance characteristics 5.1 Output rating
34	5.2 Capabilities
35	5.3 Voltage and current ratings 5.4 Power factor and reactive power capability
36	5.5 Short-circuit ratio
37	5.6 Transient and subtransient reactances 5.7 Total harmonic distortion
38	6. Insulation systems 6.1 Insulation systems defined
39	6.2 Classes of insulation systems
40	6.3 The use of different classes of insulation systems
41	7. Temperatures and temperature limits 7.1 Temperature limits
44	7.2 Methods of temperature determination
45	7.3 Locations of embedded temperature detectors 7.4 Location of coolant temperature detectors 8. Efficiency 8.1 Methods 8.2 Reference conditions
46	8.3 Types of losses
47	8.4 Test tolerance on losses
48	9. Tests 9.1 Categories and scope of tests
49	9.2 Test procedural requirements
51	9.3 Heat exchanger testing 9.4 Testing high-voltage terminal bushings 9.5 Overspeed testing
52	9.6 Sudden short-circuit testing 10. Marking 10.1 Nameplate
53	10.2 Information about other output capabilities
54	Annex A (informative) Bibliography
56	Annex B (informative) Guide for the basic specification of generators