IEEE C63.5 2004
$44.96
American National Standard for Electromagnetic CompatibilityRadiated Emission Measurements in Electromagnetic Interference (EMI) ControlCalibration of Antennas (9 kHz to 40 GHz)
Published By | Publication Date | Number of Pages |
IEEE | 2004 | 73 |
Revision Standard – Active. Superseded by ANSI C63.6-2006 Methods for determining antenna factors of antennas used for radiated emission measurements of electromagnetic interference (EMI) from 9 kHz to 40 GHz are provided. Antennas included are linearly polarized antennas such as loops, rods (monopoles), tuned dipoles, biconical dipoles, log-periodic dipole arrays, hybrid linearly polarized arrays, broadband horns, etc., which are used in measurements governed by ANSI C63.4-2001. The methods include standard site (i.e. 3-antenna), reference antenna, equivalent capacitance substitution, standard transmitting loop, standard antenna, and standard field methods.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Cover |
2 | Title Page |
3 | Abstract/Keywords |
5 | Introduction Participants |
8 | CONTENTS |
11 | 1. Scope 2. References |
12 | 3. Definitions |
13 | 4. General test conditions 4.1 Introduction |
14 | 4.2 Calibration measurement geometry 4.3 Test site and instrumentation |
15 | 4.4 Antenna factors |
16 | 4.5 Methods of antenna factor determination 5. Standard site method (30 MHz to 40 GHz) 5.1 General |
19 | 5.2 Description of method |
21 | 5.3 Measurement procedures |
24 | 6. Reference antenna method (30 MHz to 1 GHz) 6.1 Calibration of other antennas using the reference dipole ant |
25 | 6.2 Description of the reference antenna |
26 | 7. Equivalent capacitance substitution method |
27 | 7.1 Radio-noise meter and signal generator procedure 7.2 Network analyzer procedure |
29 | Annex A (informative) Determination of the maximum received field (Tables 2 and 3) |
32 | Annex B (informative) The discrete frequency calibration method |
38 | Annex C (informative) The reference antenna |
40 | Annex D (informative) Monopole performance equations |
42 | Annex E (informative) Example drawings of reference antenna [B5] |
48 | Annex F (informative) Rationale for geometry specific correction factors for biconical dipoles used in the normalized site attenuation test |
50 | Annex G (normative) Biconical dipole antenna correction factors (30-200 MHz) for calibration and normalized site attenuation |
57 | Annex H (normative) Procedure for measuring geometry specific correction factors for broadband antennas and reference-site requirements |
64 | Annex I (informative) Guideline for computing estimated measurement uncertainties in SSM antenna calibrations |
72 | Annex J (informative) Bibliography |