IEEE ISO IEC 62271 111 2006

$107.79

IEC 62271-111 Ed.1 (IEEE Std C37.60-2003-Compilation): High Voltage Switchgear and Controlgear Part 111: Overhead, Pad-Mounted, Dry Vault, and Submersible Automatic Circuit Reclosers and Fault Interrupters for alternating current systems up to 38 kV

Published By	Publication Date	Number of Pages
IEEE	2006	79

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

– Active. This Standard applies to all overhead, pad mounted, dry vault and submersible single or multi-pole alternating current automatic circuit reclosers and fault interrupters for rated maximum voltages above 1000 V and up to 38 kV. The following is also included in section 1: In order to simplify this standard where possible, the term recloser/FI (reclosers/FIs) has been substituted for automatic circuit recloser or fault interrupter or both. NOTE–When reclosers are applied in substation, special considerations may apply.

PDF Catalog

PDF Pages	PDF Title
1	IEC 62271-111 Front Cover
3	Title Page
5	Contents
7	Foreword
10	IEEE Introduction
11	1. Scope 2. References
13	3. Definitions
14	4. Service conditions 4.1 Usual service conditions 4.2 Unusual service conditions
15	5. Rating 5.1 Rating information 5.2 Rated maximum voltage
16	5.3 Rated power-frequency 5.4 Rated continuous current
17	5.5 Rated minimum tripping current… 5.6 Rated symmetrical interrupting current
19	5.7 Rated symmetrical making current 5.8 Rated lightning impulse withstand voltage 5.9 Rated control voltage and ranges 5.10 Rated line and cable charging interrupting currents (where applicable)
25	6. Design tests (type tests) 6.1 General 6.2 Insulation (dielectric) tests
28	6.3 Switching tests
31	6.4 Making current capability 6.5 Rated symmetrical interrupting current tests
42	6.6 Minimum tripping current tests
43	6.7 Partial discharge (corona) tests
44	6.8 Radio influence voltage tests (RIV)
45	6.9 Surge current test; series-trip reclosers/FIs
46	6.10 Temperature rise test
48	6.11 Time-current tests
49	6.12 Mechanical duty test 6.13 Control electronic elements surge withstand capability (SWC) tests
51	6.14 Condition of recloser/FI after each test of…
52	7. Production tests (routine tests)
53	7.1 Reclosing and overcurrent trip calibration 7.2 Control, secondary wiring, and accessory devices check tests 7.3 Dielectric withstand test; 1-min. dry power-frequency 7.4 Partial discharge test 7.5 Mechanical operations tests
54	7.6 Water leak test 8. Field tests on units in service, including dc…
55	9. Construction requirements 9.1 Tank construction: submersible or dry vault reclosers/FIs 9.2 Grounding provisions
56	9.3 Insulating medium quantity indicators 9.4 Oil sampling provision (submersible reclosers/FIs) 9.5 Manual operating provision 9.6 Position indicator 9.7 Nameplate markings
57	9.8 Stored energy mechanism charge indicator 9.9 Enclosure integrity 9.10 Counters 9.11 Conductor terminal sizes 9.12 Tank construction-pressurized reclosers/FIs only
58	Annex A (informative)
60	Annex B (informative)
63	Annex C (normative)
65	Annex D (informative)
69	Annex E (informative)
72	Annex F (informative)
73	Annex G (informative)

Additional information

Standard Title	IEC 62271-111 Ed.1 (IEEE Std C37.60-2003-Compilation): High Voltage Switchgear and Controlgear Part 111: Overhead, Pad-Mounted, Dry Vault, and Submersible Automatic Circuit Reclosers and Fault Interrupters for alternating current systems up to 38 kV
Published Code	IEEE
Publication Date	2006
Pages Count	79

Preview PDF


PDF Format	Searchable	Printable	Preview Now

IEEE ISO IEC 62271 111 2006

PDF Catalog

Related products