Shopping Cart

No products in the cart.

ISA 75.01-1985 (R1995)

$15.60

Flow Equations for Sizing Control Valves

Published By Publication Date Number of Pages
ISA 1995-10-18 52
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Full Description

Formerly S75.01. Presents equations for predicting the flow of compressible and incompressible fluids
through control valves. The equations are not intended for use when mixed-phase
fluids, dense slurries, dry solids, or non-Newtonian liquids are encountered. In addition,
the prediction of cavitation, noise, or other effects is not a part of this standard.

Scope:
This standard presents equations for predicting the flow of compressible and
incompressible fluids through control valves. The equations are not intended for use
when mixed-phase fluids, dense slurries, dry solids, or non-Newtonian liquids are
encountered. In addition, the prediction of cavitation, noise, or other effects is not a
part of this standard.

Purpose:
The equations of this standard are based on the use of experimentally determined
capacity factors obtained by testing control valve specimens according to the
procedures of ANSI/ISA-75.02-1996, 'Control Valve Capacity Test Procedures'.

The equations are used to predict the flow rate of a fluid through a valve when all the
factors, including those related to the fluid and its flowing condition, are known. When
the equations are used to select a valve size, it is often necessary to use capacity
factors associated with the fully open or rated condition to predict an approximate
required valve flow coefficient (Cv). This procedure is further explained in Annex A.

ISA 75.01-1985 (R1995)
$15.60